[PATCH v1 1/1] arm64: zynqmp: Add output-enable pins to SOMs

[Neal Frager]

Now that the zynqmp pinctrl driver supports the tri-state registers, make
sure that the pins requiring output-enable are configured appropriately for
SOMs.

Without it, all tristate setting for MIOs, which are not related to SOM
itself, are using default configuration which is not correct setting.
It means SDs, USBs, ethernet, etc. are not working properly.

In past it was fixed through calling tristate configuration via bootcmd:
usb_init=mw 0xFF180208 2020
kv260_gem3=mw 0xFF18020C 0xFC0 && gpio toggle gpio at ff0a000038 && \
  gpio toggle gpio at ff0a000038

Signed-off-by: Neal Frager <neal.frager at amd.com>
---
 arch/arm/dts/zynqmp-sck-kd-g-revA.dts | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/arch/arm/dts/zynqmp-sck-kd-g-revA.dts b/arch/arm/dts/zynqmp-sck-kd-g-revA.dts
index 56f3128528..ffdb60fa51 100644
--- a/arch/arm/dts/zynqmp-sck-kd-g-revA.dts
+++ b/arch/arm/dts/zynqmp-sck-kd-g-revA.dts
@@ -175,6 +175,7 @@
 		conf-tx {
 			pins = "MIO36";
 			bias-disable;
+			output-enable;
 		};
 
 		mux {
@@ -220,12 +221,14 @@
 		conf-rx {
 			pins = "MIO45", "MIO46", "MIO47", "MIO48";
 			bias-disable;
+			output-enable;
 			low-power-disable;
 		};
 
 		conf-bootstrap {
 			pins = "MIO44", "MIO49";
 			bias-disable;
+			output-enable;
 			low-power-disable;
 		};
 
@@ -233,6 +236,7 @@
 			pins = "MIO38", "MIO39", "MIO40",
 				"MIO41", "MIO42", "MIO43";
 			bias-disable;
+			output-enable;
 			low-power-enable;
 		};
 
@@ -241,6 +245,7 @@
 			slew-rate = <SLEW_RATE_SLOW>;
 			power-source = <IO_STANDARD_LVCMOS18>;
 			bias-disable;
+			output-enable;
 		};
 
 		mux-mdio {
@@ -271,6 +276,7 @@
 			pins = "MIO54", "MIO56", "MIO57", "MIO58", "MIO59",
 			"MIO60", "MIO61", "MIO62", "MIO63";
 			bias-disable;
+			output-enable;
 			drive-strength = <4>;
 			slew-rate = <SLEW_RATE_SLOW>;
 		};
@@ -298,6 +304,7 @@
 			pins = "MIO66", "MIO68", "MIO69", "MIO70", "MIO71",
 			"MIO72", "MIO73", "MIO74", "MIO75";
 			bias-disable;
+			output-enable;
 			drive-strength = <4>;
 			slew-rate = <SLEW_RATE_SLOW>;
 		};
-- 
2.25.1