[PATCH v3 7/7] config: Enable USB 2.0 for Radxa CM3-IO

[Jagan Teki]

=> usb start
starting USB...
Bus usb at fd800000: USB EHCI 1.00
scanning bus usb at fd800000 for devices... 4 USB Device(s) found
       scanning usb for storage devices... 1 Storage Device(s) found
=> usb tree
USB device tree:
  1  Hub (480 Mb/s, 0mA)
  |  u-boot EHCI Host Controller
  |
  +-2  Hub (480 Mb/s, 100mA)
    |   USB 2.0 Hub
    |
    +-3  Mass Storage (480 Mb/s, 224mA)
    |    SanDisk Dual Drive 04019c9b2e1a58f24ee318c3c123aa5
    |
    +-4  Human Interface (12 Mb/s, 100mA)
         CX 2.4G Receiver

Co-developed-by: Manoj Sai <abbaraju.manojsai at amarulasolutions.com>
Signed-off-by: Manoj Sai <abbaraju.manojsai at amarulasolutions.com>
Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
---
Changes for v3:
- new patch

 configs/radxa-cm3-io-rk3566_defconfig | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/configs/radxa-cm3-io-rk3566_defconfig b/configs/radxa-cm3-io-rk3566_defconfig
index 10b81e0c6d..404ada3323 100644
--- a/configs/radxa-cm3-io-rk3566_defconfig
+++ b/configs/radxa-cm3-io-rk3566_defconfig
@@ -39,6 +39,7 @@ CONFIG_SPL_STACK_R=y
 CONFIG_SPL_ATF=y
 CONFIG_CMD_GPT=y
 CONFIG_CMD_MMC=y
+CONFIG_CMD_USB=y
 # CONFIG_CMD_SETEXPR is not set
 # CONFIG_SPL_DOS_PARTITION is not set
 CONFIG_SPL_OF_CONTROL=y
@@ -58,11 +59,15 @@ CONFIG_MMC_SDHCI_SDMA=y
 CONFIG_MMC_SDHCI_ROCKCHIP=y
 CONFIG_ETH_DESIGNWARE=y
 CONFIG_GMAC_ROCKCHIP=y
+CONFIG_PHY_ROCKCHIP_INNO_USB2=y
 CONFIG_REGULATOR_PWM=y
 CONFIG_PWM_ROCKCHIP=y
 CONFIG_SPL_RAM=y
 CONFIG_BAUDRATE=1500000
 CONFIG_DEBUG_UART_SHIFT=2
 CONFIG_SYSRESET=y
+CONFIG_USB=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_EHCI_GENERIC=y
 # CONFIG_BINMAN_FDT is not set
 CONFIG_ERRNO_STR=y
-- 
2.25.1