[RESEND PATCH v2] arm: mvebu: Power up 2nd SATA port for Thecus N2350
Stefan Roese
sr at denx.de
Mon Feb 13 15:00:10 CET 2023
On 2/7/23 02:00, Tony Dinh wrote:
> Currently, only the 1st SATA port is powered up (by GPIO1 12).
> Add GPIO1 13 in board initialization to power up the 2nd SATA port.
>
> Note that this patch depends on the initial add-support patch:
> https://patchwork.ozlabs.org/project/uboot/patch/20230201231306.7010-1-mibodhi@gmail.com/
>
> Signed-off-by: Tony Dinh <mibodhi at gmail.com>
Applied to u-boot-marvell/master
Thanks,
Stefan
> ---
>
> Changes in v2:
> - Use BIT macros to make it easier to see which GPIOs are used.
> - Resent to correct missing BIT(0) in N2350_GPP_OUT_VAL_MID
>
> board/thecus/n2350/n2350.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/board/thecus/n2350/n2350.c b/board/thecus/n2350/n2350.c
> index 4cfdfba662..fd8f95f944 100644
> --- a/board/thecus/n2350/n2350.c
> +++ b/board/thecus/n2350/n2350.c
> @@ -24,8 +24,8 @@ DECLARE_GLOBAL_DATA_PTR;
>
> #define N2350_GPP_OUT_ENA_LOW (~(BIT(20) | BIT(21) | BIT(24)))
> #define N2350_GPP_OUT_ENA_MID (~(BIT(12) | BIT(13) | BIT(16) | BIT(19) | BIT(22)))
> -#define N2350_GPP_OUT_VAL_LOW 0x1200000
> -#define N2350_GPP_OUT_VAL_MID 0x1001
> +#define N2350_GPP_OUT_VAL_LOW (BIT(21) | BIT(24))
> +#define N2350_GPP_OUT_VAL_MID (BIT(0) | BIT(12) | BIT(13))
> #define N2350_GPP_POL_LOW 0x0
> #define N2350_GPP_POL_MID 0x0
>
Viele Grüße,
Stefan Roese
--
DENX Software Engineering GmbH, Managing Director: Erika Unter
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: sr at denx.de
More information about the U-Boot
mailing list