[PATCH 13/21] Makefile: Add DM, SYSFW_PATH, SYSFW_HS_INNER_CERT_PATH to BINMAN_INDIRS

[Simon Glass]

Hi Neha,

On Fri, 20 Jan 2023 at 03:19, Neha Malcom Francis <n-francis at ti.com> wrote:
>
> To remain consistent with the build commands utilised for K3 devices,
> we add the paths where component binaries are located to BINMAN_INDIRS.
> Adding SYSFW_PATH for system firmware binaries, SYSFW_HS_INNER_CERT_PATH
> for HS device certificate and DM for Device Manager firmware.
> This way, the existing build command does not change even though we
> migrate to using binman.
>
> Signed-off-by: Neha Malcom Francis <n-francis at ti.com>
> ---
>  Makefile | 16 ++++++++++++++++
>  1 file changed, 16 insertions(+)
>
> diff --git a/Makefile b/Makefile
> index c568a6e59a..218cb675fc 100644
> --- a/Makefile
> +++ b/Makefile
> @@ -1317,6 +1317,22 @@ u-boot.ldr:      u-boot
>  # Use 'make BINMAN_VERBOSE=3' to set vebosity level
>  default_dt := $(if $(DEVICE_TREE),$(DEVICE_TREE),$(CONFIG_DEFAULT_DEVICE_TREE))
>
> +ifneq ($(SYSFW_PATH),)
> +override BINMAN_INDIRS += $(dir $(SYSFW_PATH))
> +endif
> +
> +ifneq ($(SYSFW_HS_PATH),)
> +override BINMAN_INDIRS += $(dir $(SYSFW_HS_PATH))
> +endif
> +
> +ifneq ($(SYSFW_HS_INNER_CERT_PATH),)
> +override BINMAN_INDIRS += $(dir $(SYSFW_HS_INNER_CERT_PATH))
> +endif
> +
> +ifneq ($(DM),)
> +override BINMAN_INDIRS += $(dir $(DM))
> +endif
> +
>  quiet_cmd_binman = BINMAN  $@
>  cmd_binman = $(srctree)/tools/binman/binman $(if $(BINMAN_DEBUG),-D) \
>                 $(foreach f,$(BINMAN_TOOLPATHS),--toolpath $(f)) \
> --
> 2.34.1
>

Let's try to do this another way as it needs to use a bintool for the
tool that you run. See my other comments.

Regards,
Simon