[PATCH 171/171] Correct SPL uses of ZYNQMP_FIRMWARE

[Simon Glass]

This converts 2 usages of this option to the non-SPL form, since there is
no SPL_ZYNQMP_FIRMWARE defined in Kconfig

Signed-off-by: Simon Glass <sjg at chromium.org>
---

 drivers/spi/cadence_ospi_versal.c | 2 +-
 drivers/spi/cadence_qspi.c        | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/cadence_ospi_versal.c b/drivers/spi/cadence_ospi_versal.c
index e0d5e6b9e69..434c6038f3b 100644
--- a/drivers/spi/cadence_ospi_versal.c
+++ b/drivers/spi/cadence_ospi_versal.c
@@ -216,7 +216,7 @@ int cadence_qspi_versal_flash_reset(struct udevice *dev)
 
 void cadence_qspi_apb_enable_linear_mode(bool enable)
 {
-	if (CONFIG_IS_ENABLED(ZYNQMP_FIRMWARE)) {
+	if (IS_ENABLED(CONFIG_ZYNQMP_FIRMWARE)) {
 		if (enable)
 			/* ahb read mode */
 			xilinx_pm_request(PM_IOCTL, PM_DEV_OSPI,
diff --git a/drivers/spi/cadence_qspi.c b/drivers/spi/cadence_qspi.c
index 3ce5f8fb8d8..c7f10c50132 100644
--- a/drivers/spi/cadence_qspi.c
+++ b/drivers/spi/cadence_qspi.c
@@ -215,7 +215,7 @@ static int cadence_spi_probe(struct udevice *bus)
 	priv->tchsh_ns		= plat->tchsh_ns;
 	priv->tslch_ns		= plat->tslch_ns;
 
-	if (CONFIG_IS_ENABLED(ZYNQMP_FIRMWARE))
+	if (IS_ENABLED(CONFIG_ZYNQMP_FIRMWARE))
 		xilinx_pm_request(PM_REQUEST_NODE, PM_DEV_OSPI,
 				  ZYNQMP_PM_CAPABILITY_ACCESS, ZYNQMP_PM_MAX_QOS,
 				  ZYNQMP_PM_REQUEST_ACK_NO, NULL);
-- 
2.39.1.456.gfc5497dd1b-goog