[PATCH] pinctrl: mediatek: set R1/R0 in case pullen/pullsel succeeded

[Tom Rini]

On Wed, Apr 12, 2023 at 09:36:43PM +0100, Daniel Golle wrote:

> Commit dafe0fbfb0f3 ("pinctrl: mediatek: rewrite mtk_pinconf_set and
> related functions") changed the logic deciding to set R0 and R1
> registers for V1 devices.
> 
> Before:
> 	/* Also set PUPD/R0/R1 if the pin has them */
> 	err = mtk_hw_set_value(dev, pin, PINCTRL_PIN_REG_PUPD, !pullup);
> 	if (err != -EINVAL) {
> 		mtk_hw_set_value(dev, pin, PINCTRL_PIN_REG_R0, r0);
> 		mtk_hw_set_value(dev, pin, PINCTRL_PIN_REG_R1, r1);
> 	}
> 
> After:
> 	/* try pupd_r1_r0 if pullen_pullsel return error */
> 	err = mtk_pinconf_bias_set_pullen_pullsel(dev, pin, disable, pullup,
> 						  val);
> 	if (err)
> 		return mtk_pinconf_bias_set_pupd_r1_r0(dev, pin, disable,
> 						       pullup, val);
> 
> Tracing mtk_pinconf_bias_set_pullen_pullsel shows that the function
> always either returns 0 in case of success or -EINVAL in case any error
> has occurred. Hence the logic responsible of the decision to program R0
> and R1 has been inverted.
> 
> This leads to problems on BananaPi R2 (MT7623N) when booting from
> SDMMC, it turns out accessing eMMC no longer works since
> U-Boot 2022.07:
> 
> MT7623> mmc dev 0
> Card did not respond to voltage select! : -110
> 
> The problem wasn't detected for a long time as both eMMC and SDMMC work
> fine if they are used to boot from, and hence R0 and R1 were already
> setup by the bootrom and/or preloader.
> 
> Fix the logic to restore the originally intended and correct behavior
> and also change the descriptive comment accordingly.
> 
> Fixes: dafe0fbfb0f3 ("pinctrl: mediatek: rewrite mtk_pinconf_set and related functions")
> Signed-off-by: Daniel Golle <daniel at makrotopia.org>
> Tested-By: Frank Wunderlich <frank-w at public-files.de>

Applied to u-boot/master, thanks!

-- 
Tom
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 659 bytes
Desc: not available
URL: <https://lists.denx.de/pipermail/u-boot/attachments/20230503/7b3253e2/attachment.sig>