orangepi zero3

[Stephen Graf]

I have been able to build a working (on my orangepi zero3 1G) u-boot for 
the orangepi zero3 with the following defconfig. Would it be possible to 
add this config to the working boards.  I would test it again with an 
official build. The dtb/dts is in linux and in u-boot.

The H618 processor is software compatible with the H616 and the zero3 
board is very similar to the zero2 with the exception of DDR3 replaced 
with LPDDR4 and the Realtek phy with Motorcomm.

CONFIG_ARM=y
CONFIG_ARCH_SUNXI=y
CONFIG_DEFAULT_DEVICE_TREE="sun50i-h618-orangepi-zero3"
CONFIG_SPL=y
CONFIG_DRAM_SUN50I_H616_DX_ODT=0x07070707
CONFIG_DRAM_SUN50I_H616_DX_DRI=0x0e0e0e0e
CONFIG_DRAM_SUN50I_H616_CA_DRI=0x0e0e
CONFIG_DRAM_SUN50I_H616_ODT_EN=0xaaaaeeee
CONFIG_DRAM_SUN50I_H616_TPR0=0x0
CONFIG_DRAM_SUN50I_H616_TPR6=0x44000000
CONFIG_DRAM_SUN50I_H616_TPR10=0x402f0663
CONFIG_DRAM_SUN50I_H616_TPR11=0x24242323
CONFIG_DRAM_SUN50I_H616_TPR12=0x0e0e0e0e
CONFIG_MACH_SUN50I_H616=y
CONFIG_SUNXI_DRAM_H616_LPDDR4=y
CONFIG_DRAM_CLK=792
CONFIG_R_I2C_ENABLE=y
CONFIG_SPL_SPI_SUNXI=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_SPL_I2C=y
CONFIG_SPL_SYS_I2C_LEGACY=y
CONFIG_SYS_I2C_MVTWSI=y
CONFIG_SYS_I2C_SLAVE=0x7f
CONFIG_SYS_I2C_SPEED=400000
CONFIG_SPI_FLASH_MACRONIX=y
CONFIG_PHY_MOTORCOMM=y
CONFIG_SUN8I_EMAC=y
CONFIG_SPI=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_OHCI_HCD=y
CONFIG_USB_MUSB_GADGET=y
CONFIG_AXP313_POWER=y
CONFIG_AXP_DCDC3_VOLT=1100
CONFIG_CMD_BOOTZ=y