[PATCH v2 1/5] arm: mach-k3: common: Reserve video memory from end of the RAM

[Devarsh Thakkar]

Add function spl_reserve_video which is a wrapper
around video_reserve to setup video memory and update
the relocation address pointer.

Setup video memory before page table reservation so that
framebuffer memory gets reserved from the end of RAM.

This is as per the new policy being discussed for passing
blobs where each of the reserved areas for bloblists
to be passed need to be reserved at the end of RAM.

This is done to enable the next stage to directly skip
the pre-reserved area from previous stage right from the end of RAM
without having to make any gaps/holes to accommodate those
regions which was the case before as previous stage
reserved region not from the end of RAM.

Suggested-by: Simon Glass <sjg at chromium.org>
Signed-off-by: Devarsh Thakkar <devarsht at ti.com>
---
V2: Make a generic function "spl_reserve_video" under
    common/spl which can be re-used by other platforms too
    for reserving video memory from spl.
---
 arch/arm/mach-k3/common.c |  2 ++
 common/spl/spl.c          | 19 +++++++++++++++++++
 include/spl.h             |  4 ++++
 3 files changed, 25 insertions(+)

diff --git a/arch/arm/mach-k3/common.c b/arch/arm/mach-k3/common.c
index c3006ba387..03e3b46282 100644
--- a/arch/arm/mach-k3/common.c
+++ b/arch/arm/mach-k3/common.c
@@ -537,6 +537,8 @@ void spl_enable_dcache(void)
 	if (ram_top >= 0x100000000)
 		ram_top = (phys_addr_t) 0x100000000;
 
+	gd->relocaddr = ram_top;
+	spl_reserve_video();
 	gd->arch.tlb_addr = ram_top - gd->arch.tlb_size;
 	gd->arch.tlb_addr &= ~(0x10000 - 1);
 	debug("TLB table from %08lx to %08lx\n", gd->arch.tlb_addr,
diff --git a/common/spl/spl.c b/common/spl/spl.c
index 732d90d39e..89172f2ebf 100644
--- a/common/spl/spl.c
+++ b/common/spl/spl.c
@@ -41,6 +41,7 @@
 #include <fdt_support.h>
 #include <bootcount.h>
 #include <wdt.h>
+#include <video.h>
 
 DECLARE_GLOBAL_DATA_PTR;
 DECLARE_BINMAN_MAGIC_SYM;
@@ -151,6 +152,24 @@ void spl_fixup_fdt(void *fdt_blob)
 #endif
 }
 
+int spl_reserve_video(void)
+{
+	if (CONFIG_IS_ENABLED(VIDEO)) {
+		ulong addr;
+		int ret;
+
+		addr = gd->relocaddr;
+		ret = video_reserve(&addr);
+		if (ret)
+			return ret;
+		debug("Reserving %luk for video at: %08lx\n",
+		      ((unsigned long)gd->relocaddr - addr) >> 10, addr);
+		gd->relocaddr = addr;
+	}
+
+	return 0;
+}
+
 ulong spl_get_image_pos(void)
 {
 	if (!CONFIG_IS_ENABLED(BINMAN_UBOOT_SYMBOLS))
diff --git a/include/spl.h b/include/spl.h
index 0d49e4a454..9682e51fc1 100644
--- a/include/spl.h
+++ b/include/spl.h
@@ -825,6 +825,10 @@ int spl_usb_load(struct spl_image_info *spl_image,
 
 int spl_ymodem_load_image(struct spl_image_info *spl_image,
 			  struct spl_boot_device *bootdev);
+/**
+ * spl_reserve_video() - Reserve video and update relocation address
+ */
+int spl_reserve_video(void);
 
 /**
  * spl_invoke_atf - boot using an ARM trusted firmware image
-- 
2.34.1