[PATCH v2] rockchip: px30-board-tpl: Use CONFIG_TPL_BANNER_PRINT flag

[lukasz.czechowski at thaumatec.com]

From: Lukasz Czechowski <lukasz.czechowski at thaumatec.com>

Display TPL init information message only when TPL_BANNER_PRINT
configuration entry is set. This allows to disable information
message in case logs on UART are unwanted.
Update parent ifdef condition to check also CONFIG_TPL_SERIAL
to match logic of the non-PX30 TPL implementation.

Signed-off-by: Lukasz Czechowski <lukasz.czechowski at thaumatec.com>
Cc: Tom Rini <trini at konsulko.com>
Cc: Simon Glass <sjg at chromium.org>
Cc: Philipp Tomsich <philipp.tomsich at vrull.eu>
Cc: Kever Yang <kever.yang at rock-chips.com>

---
Changes for v2:
- Updated parent ifdef condition
---
 arch/arm/mach-rockchip/px30-board-tpl.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/arch/arm/mach-rockchip/px30-board-tpl.c b/arch/arm/mach-rockchip/px30-board-tpl.c
index 637a5e1b18..db368a7b8c 100644
--- a/arch/arm/mach-rockchip/px30-board-tpl.c
+++ b/arch/arm/mach-rockchip/px30-board-tpl.c
@@ -36,7 +36,7 @@ void board_init_f(ulong dummy)
 {
 	int ret;
 
-#ifdef CONFIG_DEBUG_UART
+#if defined(CONFIG_DEBUG_UART) && defined(CONFIG_TPL_SERIAL)
 	debug_uart_init();
 	/*
 	 * Debug UART can be used from here if required:
@@ -46,7 +46,9 @@ void board_init_f(ulong dummy)
 	 * printhex8(0x1234);
 	 * printascii("string");
 	 */
+#if CONFIG_TPL_BANNER_PRINT
 	printascii("U-Boot TPL board init\n");
+#endif
 #endif
 
 	secure_timer_init();
-- 
2.34.1