[PATCH] riscv: dts: jh7110: Enable PLL node in SPL

[Bo Gan]

On 4/16/24 9:59 PM, E Shattow wrote:
> On Tue, Apr 9, 2024 at 11:44 PM Bo Gan <ganboing at gmail.com> wrote:
>>
>> On 4/9/24 6:55 PM, E Shattow wrote:
>>> Original speed class SD cards fail with this change "unable to change mode".
>>>
>>
>> The BUS_ROOT clock will have to be switched to PLL2 anyway in U-Boot proper or
>> in Linux, because it's the parent or grandparent clock for *lots* of devices,
>> including PCIe, i2c, spi, qspi... If there's an issue with this change, then
>> I suspect there's something wrong with the dw_mmc driver.
>>
>> Bo
> 
> I've bisected and can confirm this change is what breaks original
> speed SD function on Milk-V Mars CM Lite (DFRobot mini router
> carrier). Class 10 speed SD media does not seem to be affected.
> Reverting the change allows the original speed SD media access to
> function again. SD access is functional in Linux with and without the
> change.
> 
> How to troubleshoot this?
> 
> Thanks,
> 
> E
> 

If without the change (reverted), can you read/write the same SD media in U-boot
proper? (U-boot proper will switch BUS_ROOT to PLL2). One potential problem I
could think of is perhaps the SPL built is without SPL_PINCTRL_STARFIVE/JH7110
or the u-boot dts is missing the pinctrl that properly sets drive-strength and
other properties of the mmc0/1 pins. What dtb are you using? I tested this with
visionfive2 and it's working fine. Can you share the tree/config you used to
built for Milk-V Mars CM Lite? I don't see the corresponding dts being checked-
in to u-boot tree, so it helps if you can share the code. Thanks!

Bo