[PATCH 20/31] rockchip: rk3399-leez: Sync device tree from linux v6.8

[Kever Yang]

On 2024/4/1 04:28, Jonas Karlman wrote:
> Sync rk3399-leez-p710 device tree from linux v6.8.
>
> Add DM_RESET=y to support reset signals.
>
> Change to SPL_MAX_SIZE=0x40000, SPL can be up to 256 KiB.
>
> Add ROCKCHIP_IODOMAIN=y to configure io-domain voltage.
>
> Add MMC_SDHCI_SDMA=y to use DMA transfer for eMMC.
>
> Add PHY_REALTEK=y and DM_ETH_PHY=y to support ethernet PHY.
>
> Add PHY_ROCKCHIP_INNO_USB2=y and PHY_ROCKCHIP_TYPEC=y to support USB PHY.
>
> Remove SPL_TINY_MEMSET=y to use full memset in SPL.
>
> Signed-off-by: Jonas Karlman <jonas at kwiboo.se>
Reviewed-by: Kever Yang <kever.yang at rock-chips.com>

Thanks,
- Kever
> ---
>   arch/arm/dts/rk3399-leez-p710.dts |  8 +++++---
>   configs/leez-rk3399_defconfig     | 10 ++++++++--
>   2 files changed, 13 insertions(+), 5 deletions(-)
>
> diff --git a/arch/arm/dts/rk3399-leez-p710.dts b/arch/arm/dts/rk3399-leez-p710.dts
> index 7c93f840bc64..cb69e2145fa9 100644
> --- a/arch/arm/dts/rk3399-leez-p710.dts
> +++ b/arch/arm/dts/rk3399-leez-p710.dts
> @@ -5,6 +5,7 @@
>   
>   /dts-v1/;
>   #include <dt-bindings/input/linux-event-codes.h>
> +#include <dt-bindings/interrupt-controller/irq.h>
>   #include <dt-bindings/pwm/pwm.h>
>   #include "rk3399.dtsi"
>   #include "rk3399-opp.dtsi"
> @@ -14,6 +15,7 @@
>   	compatible = "leez,p710", "rockchip,rk3399";
>   
>   	aliases {
> +		ethernet0 = &gmac;
>   		mmc0 = &sdio0;
>   		mmc1 = &sdmmc;
>   		mmc2 = &sdhci;
> @@ -55,7 +57,7 @@
>   		regulator-boot-on;
>   		regulator-min-microvolt = <3300000>;
>   		regulator-max-microvolt = <3300000>;
> -		vim-supply = <&vcc3v3_sys>;
> +		vin-supply = <&vcc3v3_sys>;
>   	};
>   
>   	vcc3v3_sys: vcc3v3-sys {
> @@ -102,12 +104,12 @@
>   	vdd_log: vdd-log {
>   		compatible = "pwm-regulator";
>   		pwms = <&pwm2 0 25000 1>;
> +		pwm-supply = <&vcc5v0_sys>;
>   		regulator-name = "vdd_log";
>   		regulator-always-on;
>   		regulator-boot-on;
>   		regulator-min-microvolt = <800000>;
>   		regulator-max-microvolt = <1400000>;
> -		vin-supply = <&vcc5v0_sys>;
>   	};
>   };
>   
> @@ -509,7 +511,7 @@
>   		compatible = "brcm,bcm4329-fmac";
>   		reg = <1>;
>   		interrupt-parent = <&gpio0>;
> -		interrupts = <RK_PA3 GPIO_ACTIVE_HIGH>;
> +		interrupts = <RK_PA3 IRQ_TYPE_LEVEL_HIGH>;
>   		interrupt-names = "host-wake";
>   		pinctrl-names = "default";
>   		pinctrl-0 = <&wifi_host_wake_l>;
> diff --git a/configs/leez-rk3399_defconfig b/configs/leez-rk3399_defconfig
> index 13453e523444..903125aa5c1d 100644
> --- a/configs/leez-rk3399_defconfig
> +++ b/configs/leez-rk3399_defconfig
> @@ -5,6 +5,7 @@ CONFIG_ARCH_ROCKCHIP=y
>   CONFIG_NR_DRAM_BANKS=1
>   CONFIG_ENV_OFFSET=0x3F8000
>   CONFIG_DEFAULT_DEVICE_TREE="rk3399-leez-p710"
> +CONFIG_DM_RESET=y
>   CONFIG_ROCKCHIP_RK3399=y
>   CONFIG_TARGET_EVB_RK3399=y
>   CONFIG_DEBUG_UART_BASE=0xFF1A0000
> @@ -13,7 +14,7 @@ CONFIG_SYS_LOAD_ADDR=0x800800
>   CONFIG_DEBUG_UART=y
>   CONFIG_DEFAULT_FDT_FILE="rockchip/rk3399-leez-p710.dtb"
>   CONFIG_DISPLAY_BOARDINFO_LATE=y
> -CONFIG_SPL_MAX_SIZE=0x2e000
> +CONFIG_SPL_MAX_SIZE=0x40000
>   CONFIG_SPL_PAD_TO=0x7f8000
>   # CONFIG_SPL_RAW_IMAGE_SUPPORT is not set
>   CONFIG_SPL_ATF_NO_PLATFORM_PARAM=y
> @@ -30,12 +31,18 @@ CONFIG_ENV_IS_IN_MMC=y
>   CONFIG_SYS_RELOC_GD_ENV_ADDR=y
>   CONFIG_ROCKCHIP_GPIO=y
>   CONFIG_SYS_I2C_ROCKCHIP=y
> +CONFIG_ROCKCHIP_IODOMAIN=y
>   CONFIG_MMC_DW=y
>   CONFIG_MMC_DW_ROCKCHIP=y
>   CONFIG_MMC_SDHCI=y
> +CONFIG_MMC_SDHCI_SDMA=y
>   CONFIG_MMC_SDHCI_ROCKCHIP=y
> +CONFIG_PHY_REALTEK=y
> +CONFIG_DM_ETH_PHY=y
>   CONFIG_ETH_DESIGNWARE=y
>   CONFIG_GMAC_ROCKCHIP=y
> +CONFIG_PHY_ROCKCHIP_INNO_USB2=y
> +CONFIG_PHY_ROCKCHIP_TYPEC=y
>   CONFIG_PMIC_RK8XX=y
>   CONFIG_REGULATOR_PWM=y
>   CONFIG_REGULATOR_RK8XX=y
> @@ -57,5 +64,4 @@ CONFIG_USB_ETHER_ASIX88179=y
>   CONFIG_USB_ETHER_MCS7830=y
>   CONFIG_USB_ETHER_RTL8152=y
>   CONFIG_USB_ETHER_SMSC95XX=y
> -CONFIG_SPL_TINY_MEMSET=y
>   CONFIG_ERRNO_STR=y