[PATCH v1 1/2] pinctrl: tegra20: adjust pin type detection

[Svyatoslav Ryhel]

Pin detection on t20 depends on node name. With recent changes
in node naming, let's remove '_' to be safe about both '_' or
'-' use.

Signed-off-by: Svyatoslav Ryhel <clamor95 at gmail.com>
---
 drivers/pinctrl/tegra/pinctrl-tegra20.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/tegra/pinctrl-tegra20.c b/drivers/pinctrl/tegra/pinctrl-tegra20.c
index d5171b8be23..d59b3ec7b5d 100644
--- a/drivers/pinctrl/tegra/pinctrl-tegra20.c
+++ b/drivers/pinctrl/tegra/pinctrl-tegra20.c
@@ -97,9 +97,9 @@ static int tegra_pinctrl_set_state(struct udevice *dev, struct udevice *config)
 		 * then actual pins setup (with node name prefix
 		 * conf_*) and then drive setup.
 		 */
-		if (!strncmp(child->name, "conf_", 5))
+		if (!strncmp(child->name, "conf", 4))
 			tegra_pinctrl_set_pin(child);
-		else if (!strncmp(child->name, "drive_", 6))
+		else if (!strncmp(child->name, "drive", 5))
 			debug("%s: drive configuration is not supported\n", __func__);
 		else
 			tegra_pinctrl_set_func(child);
-- 
2.43.0