[PATCH] board: gateworks: venice: Simplify Ethernet initialization

Tim Harvey tharvey at gateworks.com
Fri Jun 21 00:24:44 CEST 2024


With DM enabled, there is no need for board code to initialize
the Ethernet interfaces.

Specifically board_interface_eth_init will handle the configuration of
GPR1.

Signed-off-by: Tim Harvey <tharvey at gateworks.com>
---
 board/gateworks/venice/venice.c | 19 -------------------
 1 file changed, 19 deletions(-)

diff --git a/board/gateworks/venice/venice.c b/board/gateworks/venice/venice.c
index 3080ff20cb02..d4c22121497b 100644
--- a/board/gateworks/venice/venice.c
+++ b/board/gateworks/venice/venice.c
@@ -45,22 +45,6 @@ int board_fit_config_name_match(const char *path)
 	return -1;
 }
 
-static int __maybe_unused setup_fec(void)
-{
-	struct iomuxc_gpr_base_regs *gpr =
-		(struct iomuxc_gpr_base_regs *)IOMUXC_GPR_BASE_ADDR;
-
-#ifndef CONFIG_IMX8MP
-	/* Use 125M anatop REF_CLK1 for ENET1, not from external */
-	clrsetbits_le32(&gpr->gpr[1], 0x2000, 0);
-#else
-	/* Enable RGMII TX clk output */
-	setbits_le32(&gpr->gpr[1], BIT(22));
-#endif
-
-	return 0;
-}
-
 #if (IS_ENABLED(CONFIG_NET))
 int board_phy_config(struct phy_device *phydev)
 {
@@ -91,9 +75,6 @@ int board_init(void)
 {
 	venice_eeprom_init(1);
 
-	if (IS_ENABLED(CONFIG_FEC_MXC))
-		setup_fec();
-
 	return 0;
 }
 
-- 
2.25.1



More information about the U-Boot mailing list