[PATCH v4 11/16] fdt: Correct condition for bloblist existing
Simon Glass
sjg at chromium.org
Sun Jun 23 19:52:57 CEST 2024
On some boards, the bloblist is created in SPL once SDRAM is ready. It
cannot be accessed until that point, so is not available early in SPL.
Add a condition to avoid a hang in this case.
This fixes a hang in chromebook_coral
Fixes: 70fe2385943 ("fdt: Allow the devicetree to come from a bloblist")
Signed-off-by: Simon Glass <sjg at chromium.org>
---
(no changes since v3)
Changes in v3:
- Use BLOBLIST instead of OF_BLOBLIST
Changes in v2:
- Use 'phase' instead of 'stage'
lib/fdtdec.c | 12 ++++++++++--
1 file changed, 10 insertions(+), 2 deletions(-)
diff --git a/lib/fdtdec.c b/lib/fdtdec.c
index b2c59ab3818..e16d1819449 100644
--- a/lib/fdtdec.c
+++ b/lib/fdtdec.c
@@ -1669,8 +1669,16 @@ int fdtdec_setup(void)
{
int ret = -ENOENT;
- /* If allowing a bloblist, check that first */
- if (CONFIG_IS_ENABLED(BLOBLIST)) {
+ /*
+ * If allowing a bloblist, check that first. This would be better
+ * handled with an OF_BLOBLIST Kconfig, but that caused far too much
+ * argument, so add a hack here, used e.g. by chromebook_coral
+ * The necessary test is whether the previous phase passed a bloblist,
+ * not whether this phase creates one.
+ */
+ if (CONFIG_IS_ENABLED(BLOBLIST) &&
+ (spl_prev_phase() != PHASE_TPL ||
+ !IS_ENABLED(CONFIG_TPL_BLOBLIST))) {
ret = bloblist_maybe_init();
if (!ret) {
gd->fdt_blob = bloblist_find(BLOBLISTT_CONTROL_FDT, 0);
--
2.34.1
More information about the U-Boot
mailing list