[PATCH v4] Makefile: use shell to calculate map_size

[Leon M. Busch-George]

From: "Leon M. Busch-George" <leon at georgemail.eu>

The error message "bc: command not found" is easily missed since the
build continues.
bc is not a part of coreutils or base-devel. POSIX sh can also do the
calculation.

Signed-off-by: Leon M. Busch-George <leon at georgemail.eu>
Reviewed-by: Dragan Simic <dsimic at manjaro.org>
---
 Makefile | 15 ++++++++++-----
 1 file changed, 10 insertions(+), 5 deletions(-)

diff --git a/Makefile b/Makefile
index a2bc9d5903..fac3a05dd5 100644
--- a/Makefile
+++ b/Makefile
@@ -1273,12 +1273,17 @@ OBJCOPYFLAGS_u-boot-nodtb.bin := -O binary \
 		$(if $(CONFIG_MPC85XX_HAVE_RESET_VECTOR),$(if $(CONFIG_OF_SEPARATE),-R .bootpg -R .resetvec))
 
 binary_size_check: u-boot-nodtb.bin FORCE
-	@file_size=$(shell wc -c u-boot-nodtb.bin | awk '{print $$1}') ; \
+	@file_size=$(shell wc -c u-boot-nodtb.bin | awk '{ print $$1 }') ; \
 	map_size=$(shell cat u-boot.map | \
-		awk '/_image_copy_start/ {start = $$1} /_image_binary_end/ {end = $$1} END {if (start != "" && end != "") print "ibase=16; " toupper(end) " - " toupper(start)}' \
-		| sed 's/0X//g' \
-		| bc); \
-	if [ "" != "$$map_size" ]; then \
+		awk ' \
+			/_image_copy_start/ { start = $$1 } \
+			/_image_binary_end/ { end = $$1 } \
+			END { \
+				if (start != "" && end != "") \
+					print end " " start; \
+			}' \
+		| sh -c 'read end start && echo $$((end - start))'); \
+	if [ -n "$$map_size" ]; then \
 		if test $$map_size -ne $$file_size; then \
 			echo "u-boot.map shows a binary size of $$map_size" >&2 ; \
 			echo "  but u-boot-nodtb.bin shows $$file_size" >&2 ; \
-- 
2.44.0