[PATCH 05/19] spi: cadence_qspi: Clean up registers in init

[Tejas Bhumkar]

From: Ashok Reddy Soma <ashok.reddy.soma at xilinx.com>

This patch cleans up the cadence qspi registers in the init.
The register contents may be invalid if this controller is
used in previous boot and comes to uboot after a softreset
(no power on reset). This may cause issues in uboot.

Signed-off-by: Ashok Reddy Soma <ashok.reddy.soma at xilinx.com>
Signed-off-by: Tejas Bhumkar <tejas.arvind.bhumkar at amd.com>
---
 drivers/spi/cadence_qspi_apb.c | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)

diff --git a/drivers/spi/cadence_qspi_apb.c b/drivers/spi/cadence_qspi_apb.c
index 7576dacfb0..35a21a2727 100644
--- a/drivers/spi/cadence_qspi_apb.c
+++ b/drivers/spi/cadence_qspi_apb.c
@@ -340,12 +340,34 @@ void cadence_qspi_apb_controller_init(struct cadence_spi_priv *priv)
 	/* Configure the remap address register, no remap */
 	writel(0, priv->regbase + CQSPI_REG_REMAP);
 
+	/* Clear instruction read config register */
+	writel(0, priv->regbase + CQSPI_REG_RD_INSTR);
+
+	/* Reset the Delay lines */
+	writel(CQSPI_REG_PHY_CONFIG_RESET_FLD_MASK,
+	       priv->regbase + CQSPI_REG_PHY_CONFIG);
+
+	reg = readl(priv->regbase + CQSPI_REG_RD_DATA_CAPTURE);
+	reg &= ~CQSPI_REG_READCAPTURE_DQS_ENABLE;
+	reg &= ~(CQSPI_REG_RD_DATA_CAPTURE_DELAY_MASK
+		 << CQSPI_REG_RD_DATA_CAPTURE_DELAY_LSB);
+	writel(reg, priv->regbase + CQSPI_REG_RD_DATA_CAPTURE);
+
 	/* Indirect mode configurations */
 	writel(priv->fifo_depth / 2, priv->regbase + CQSPI_REG_SRAMPARTITION);
 
 	/* Disable all interrupts */
 	writel(0, priv->regbase + CQSPI_REG_IRQMASK);
 
+	reg = readl(priv->regbase + CQSPI_REG_CONFIG);
+	reg &= ~CQSPI_REG_CONFIG_DTR_PROT_EN_MASK;
+	reg &= ~CQSPI_REG_CONFIG_PHY_ENABLE_MASK;
+	reg &= ~CQSPI_REG_CONFIG_DIRECT;
+	reg &= ~(CQSPI_REG_CONFIG_CHIPSELECT_MASK
+			<< CQSPI_REG_CONFIG_CHIPSELECT_LSB);
+
+	writel(reg, priv->regbase + CQSPI_REG_CONFIG);
+
 	cadence_qspi_apb_controller_enable(priv->regbase);
 }
 
-- 
2.27.0