[PATCH 18/31] rockchip: rk3399-rock-pi-n10: Sync device tree from linux v6.8
Jonas Karlman
jonas at kwiboo.se
Sun Mar 31 22:28:24 CEST 2024
Sync rk3399-rock-pi-n10 related device tree from linux v6.8.
Remove SPL_GPIO=y, board does not use gpio in SPL.
Change to SPL_MAX_SIZE=0x40000, SPL can be up to 256 KiB.
Add ROCKCHIP_IODOMAIN=y to configure io-domain voltage.
Add MMC_SDHCI_SDMA=y to use DMA transfer for eMMC.
Add PHY_REALTEK=y and DM_ETH_PHY=y to support ethernet PHY.
Remove REGULATOR_PWM=y, board does not use pwm-regulator compatible.
Signed-off-by: Jonas Karlman <jonas at kwiboo.se>
---
arch/arm/dts/rk3288-vmarc-som.dtsi | 48 +++++++++++++++++++
arch/arm/dts/rk3399pro-vmarc-som.dtsi | 20 ++++++--
.../dts/rockchip-radxa-dalang-carrier.dtsi | 21 ++++++++
configs/rock-pi-n10-rk3399pro_defconfig | 8 ++--
4 files changed, 89 insertions(+), 8 deletions(-)
diff --git a/arch/arm/dts/rk3288-vmarc-som.dtsi b/arch/arm/dts/rk3288-vmarc-som.dtsi
index 717cb3dc816e..793951655b73 100644
--- a/arch/arm/dts/rk3288-vmarc-som.dtsi
+++ b/arch/arm/dts/rk3288-vmarc-som.dtsi
@@ -231,11 +231,43 @@
};
};
+&i2c1 {
+ clock-frequency = <400000>;
+ status = "okay";
+
+ hym8563: rtc at 51 {
+ compatible = "haoyu,hym8563";
+ reg = <0x51>;
+ interrupt-parent = <&gpio5>;
+ interrupts = <RK_PC3 IRQ_TYPE_LEVEL_LOW>;
+ #clock-cells = <0>;
+ clock-output-names = "hym8563";
+ pinctrl-names = "default";
+ pinctrl-0 = <&hym8563_int>;
+ };
+};
+
&i2c5 {
status = "okay";
};
+&io_domains {
+ bb-supply = <&vcc_io>;
+ flash0-supply = <&vccio_flash>;
+ gpio1830-supply = <&vcc_18>;
+ gpio30-supply = <&vcc_io>;
+ sdcard-supply = <&vccio_sd>;
+ wifi-supply = <&vcc_wl>;
+ status = "okay";
+};
+
&pinctrl {
+ hym8563 {
+ hym8563_int: hym8563-int {
+ rockchip,pins = <5 RK_PC3 RK_FUNC_GPIO &pcfg_pull_up>;
+ };
+ };
+
pcfg_pull_none_drv_8ma: pcfg-pull-none-drv-8ma {
drive-strength = <8>;
};
@@ -251,6 +283,12 @@
};
};
+ sdio-pwrseq {
+ wifi_enable_h: wifi-enable-h {
+ rockchip,pins = <4 RK_PD4 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
sdmmc {
sdmmc_bus4: sdmmc-bus4 {
rockchip,pins =
@@ -282,6 +320,16 @@
};
};
+&sdio_pwrseq {
+ /*
+ * On the module itself this is one of these (depending
+ * on the actual card populated):
+ * - SDIO_RESET_L_WL_REG_ON
+ * - PDN (power down when low)
+ */
+ reset-gpios = <&gpio4 RK_PD4 GPIO_ACTIVE_LOW>; /* WIFI_REG_ON */
+};
+
&usbphy {
status = "okay";
};
diff --git a/arch/arm/dts/rk3399pro-vmarc-som.dtsi b/arch/arm/dts/rk3399pro-vmarc-som.dtsi
index e1cb426f2aa5..8823c924dc1d 100644
--- a/arch/arm/dts/rk3399pro-vmarc-som.dtsi
+++ b/arch/arm/dts/rk3399pro-vmarc-som.dtsi
@@ -13,8 +13,9 @@
compatible = "vamrs,rk3399pro-vmarc-som", "rockchip,rk3399pro";
aliases {
- mmc0 = &sdmmc;
- mmc1 = &sdhci;
+ ethernet0 = &gmac;
+ mmc0 = &sdhci;
+ mmc1 = &sdmmc;
};
vcc3v3_pcie: vcc-pcie-regulator {
@@ -297,11 +298,10 @@
clock-frequency = <400000>;
status = "okay";
- hym8563: hym8563 at 51 {
+ hym8563: rtc at 51 {
compatible = "haoyu,hym8563";
reg = <0x51>;
#clock-cells = <0>;
- clock-frequency = <32768>;
clock-output-names = "hym8563";
pinctrl-names = "default";
pinctrl-0 = <&hym8563_int>;
@@ -347,7 +347,7 @@
pcie {
pcie_pwr: pcie-pwr {
- rockchip,pins = <4 RK_PD4 RK_FUNC_GPIO &pcfg_pull_up>;
+ rockchip,pins = <4 RK_PD4 RK_FUNC_GPIO &pcfg_pull_up>;
};
};
@@ -381,6 +381,16 @@
pmu1830-supply = <&vcc_1v8>;
};
+&sdio_pwrseq {
+ /*
+ * On the module itself this is one of these (depending
+ * on the actual card populated):
+ * - SDIO_RESET_L_WL_REG_ON
+ * - PDN (power down when low)
+ */
+ reset-gpios = <&gpio2 RK_PD3 GPIO_ACTIVE_LOW>;
+};
+
&sdhci {
bus-width = <8>;
mmc-hs400-1_8v;
diff --git a/arch/arm/dts/rockchip-radxa-dalang-carrier.dtsi b/arch/arm/dts/rockchip-radxa-dalang-carrier.dtsi
index 26b53eac4706..da1d548b7330 100644
--- a/arch/arm/dts/rockchip-radxa-dalang-carrier.dtsi
+++ b/arch/arm/dts/rockchip-radxa-dalang-carrier.dtsi
@@ -15,6 +15,14 @@
#clock-cells = <0>;
};
+ sdio_pwrseq: sdio-pwrseq {
+ compatible = "mmc-pwrseq-simple";
+ clocks = <&hym8563>;
+ clock-names = "ext_clock";
+ pinctrl-names = "default";
+ pinctrl-0 = <&wifi_enable_h>;
+ };
+
vcc12v_dcin: vcc12v-dcin-regulator {
compatible = "regulator-fixed";
regulator-name = "vcc12v_dcin";
@@ -78,6 +86,19 @@
status = "okay";
};
+&sdio0 {
+ bus-width = <4>;
+ cap-sd-highspeed;
+ cap-sdio-irq;
+ keep-power-in-suspend;
+ mmc-pwrseq = <&sdio_pwrseq>;
+ non-removable;
+ pinctrl-names = "default";
+ pinctrl-0 = <&sdio0_bus4 &sdio0_cmd &sdio0_clk>;
+ sd-uhs-sdr104;
+ status = "okay";
+};
+
&sdmmc {
bus-width = <4>;
cap-mmc-highspeed;
diff --git a/configs/rock-pi-n10-rk3399pro_defconfig b/configs/rock-pi-n10-rk3399pro_defconfig
index 234d0c9ab0f5..6d93b9e58003 100644
--- a/configs/rock-pi-n10-rk3399pro_defconfig
+++ b/configs/rock-pi-n10-rk3399pro_defconfig
@@ -2,7 +2,6 @@ CONFIG_ARM=y
CONFIG_SKIP_LOWLEVEL_INIT=y
CONFIG_COUNTER_FREQUENCY=24000000
CONFIG_ARCH_ROCKCHIP=y
-CONFIG_SPL_GPIO=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_ENV_OFFSET=0x3F8000
CONFIG_DEFAULT_DEVICE_TREE="rk3399pro-rock-pi-n10"
@@ -18,7 +17,7 @@ CONFIG_DEBUG_UART=y
CONFIG_DEFAULT_FDT_FILE="rockchip/rk3399pro-rock-pi-n10.dtb"
# CONFIG_CONSOLE_MUX is not set
CONFIG_DISPLAY_BOARDINFO_LATE=y
-CONFIG_SPL_MAX_SIZE=0x2e000
+CONFIG_SPL_MAX_SIZE=0x40000
CONFIG_SPL_PAD_TO=0x7f8000
# CONFIG_SPL_RAW_IMAGE_SUPPORT is not set
CONFIG_SPL_ATF_NO_PLATFORM_PARAM=y
@@ -36,17 +35,20 @@ CONFIG_ENV_IS_IN_MMC=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_ROCKCHIP_GPIO=y
CONFIG_SYS_I2C_ROCKCHIP=y
+CONFIG_ROCKCHIP_IODOMAIN=y
CONFIG_MMC_DW=y
CONFIG_MMC_DW_ROCKCHIP=y
CONFIG_MMC_SDHCI=y
+CONFIG_MMC_SDHCI_SDMA=y
CONFIG_MMC_SDHCI_ROCKCHIP=y
+CONFIG_PHY_REALTEK=y
+CONFIG_DM_ETH_PHY=y
CONFIG_ETH_DESIGNWARE=y
CONFIG_GMAC_ROCKCHIP=y
CONFIG_NVME_PCI=y
CONFIG_PHY_ROCKCHIP_INNO_USB2=y
CONFIG_PHY_ROCKCHIP_TYPEC=y
CONFIG_PMIC_RK8XX=y
-CONFIG_REGULATOR_PWM=y
CONFIG_REGULATOR_RK8XX=y
CONFIG_PWM_ROCKCHIP=y
# CONFIG_RAM_ROCKCHIP_DEBUG is not set
--
2.43.2
More information about the U-Boot
mailing list