[PATCH 20/31] rockchip: rk3399-leez: Sync device tree from linux v6.8

[Jonas Karlman]

Sync rk3399-leez-p710 device tree from linux v6.8.

Add DM_RESET=y to support reset signals.

Change to SPL_MAX_SIZE=0x40000, SPL can be up to 256 KiB.

Add ROCKCHIP_IODOMAIN=y to configure io-domain voltage.

Add MMC_SDHCI_SDMA=y to use DMA transfer for eMMC.

Add PHY_REALTEK=y and DM_ETH_PHY=y to support ethernet PHY.

Add PHY_ROCKCHIP_INNO_USB2=y and PHY_ROCKCHIP_TYPEC=y to support USB PHY.

Remove SPL_TINY_MEMSET=y to use full memset in SPL.

Signed-off-by: Jonas Karlman <jonas at kwiboo.se>
---
 arch/arm/dts/rk3399-leez-p710.dts |  8 +++++---
 configs/leez-rk3399_defconfig     | 10 ++++++++--
 2 files changed, 13 insertions(+), 5 deletions(-)

diff --git a/arch/arm/dts/rk3399-leez-p710.dts b/arch/arm/dts/rk3399-leez-p710.dts
index 7c93f840bc64..cb69e2145fa9 100644
--- a/arch/arm/dts/rk3399-leez-p710.dts
+++ b/arch/arm/dts/rk3399-leez-p710.dts
@@ -5,6 +5,7 @@
 
 /dts-v1/;
 #include <dt-bindings/input/linux-event-codes.h>
+#include <dt-bindings/interrupt-controller/irq.h>
 #include <dt-bindings/pwm/pwm.h>
 #include "rk3399.dtsi"
 #include "rk3399-opp.dtsi"
@@ -14,6 +15,7 @@
 	compatible = "leez,p710", "rockchip,rk3399";
 
 	aliases {
+		ethernet0 = &gmac;
 		mmc0 = &sdio0;
 		mmc1 = &sdmmc;
 		mmc2 = &sdhci;
@@ -55,7 +57,7 @@
 		regulator-boot-on;
 		regulator-min-microvolt = <3300000>;
 		regulator-max-microvolt = <3300000>;
-		vim-supply = <&vcc3v3_sys>;
+		vin-supply = <&vcc3v3_sys>;
 	};
 
 	vcc3v3_sys: vcc3v3-sys {
@@ -102,12 +104,12 @@
 	vdd_log: vdd-log {
 		compatible = "pwm-regulator";
 		pwms = <&pwm2 0 25000 1>;
+		pwm-supply = <&vcc5v0_sys>;
 		regulator-name = "vdd_log";
 		regulator-always-on;
 		regulator-boot-on;
 		regulator-min-microvolt = <800000>;
 		regulator-max-microvolt = <1400000>;
-		vin-supply = <&vcc5v0_sys>;
 	};
 };
 
@@ -509,7 +511,7 @@
 		compatible = "brcm,bcm4329-fmac";
 		reg = <1>;
 		interrupt-parent = <&gpio0>;
-		interrupts = <RK_PA3 GPIO_ACTIVE_HIGH>;
+		interrupts = <RK_PA3 IRQ_TYPE_LEVEL_HIGH>;
 		interrupt-names = "host-wake";
 		pinctrl-names = "default";
 		pinctrl-0 = <&wifi_host_wake_l>;
diff --git a/configs/leez-rk3399_defconfig b/configs/leez-rk3399_defconfig
index 13453e523444..903125aa5c1d 100644
--- a/configs/leez-rk3399_defconfig
+++ b/configs/leez-rk3399_defconfig
@@ -5,6 +5,7 @@ CONFIG_ARCH_ROCKCHIP=y
 CONFIG_NR_DRAM_BANKS=1
 CONFIG_ENV_OFFSET=0x3F8000
 CONFIG_DEFAULT_DEVICE_TREE="rk3399-leez-p710"
+CONFIG_DM_RESET=y
 CONFIG_ROCKCHIP_RK3399=y
 CONFIG_TARGET_EVB_RK3399=y
 CONFIG_DEBUG_UART_BASE=0xFF1A0000
@@ -13,7 +14,7 @@ CONFIG_SYS_LOAD_ADDR=0x800800
 CONFIG_DEBUG_UART=y
 CONFIG_DEFAULT_FDT_FILE="rockchip/rk3399-leez-p710.dtb"
 CONFIG_DISPLAY_BOARDINFO_LATE=y
-CONFIG_SPL_MAX_SIZE=0x2e000
+CONFIG_SPL_MAX_SIZE=0x40000
 CONFIG_SPL_PAD_TO=0x7f8000
 # CONFIG_SPL_RAW_IMAGE_SUPPORT is not set
 CONFIG_SPL_ATF_NO_PLATFORM_PARAM=y
@@ -30,12 +31,18 @@ CONFIG_ENV_IS_IN_MMC=y
 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
 CONFIG_ROCKCHIP_GPIO=y
 CONFIG_SYS_I2C_ROCKCHIP=y
+CONFIG_ROCKCHIP_IODOMAIN=y
 CONFIG_MMC_DW=y
 CONFIG_MMC_DW_ROCKCHIP=y
 CONFIG_MMC_SDHCI=y
+CONFIG_MMC_SDHCI_SDMA=y
 CONFIG_MMC_SDHCI_ROCKCHIP=y
+CONFIG_PHY_REALTEK=y
+CONFIG_DM_ETH_PHY=y
 CONFIG_ETH_DESIGNWARE=y
 CONFIG_GMAC_ROCKCHIP=y
+CONFIG_PHY_ROCKCHIP_INNO_USB2=y
+CONFIG_PHY_ROCKCHIP_TYPEC=y
 CONFIG_PMIC_RK8XX=y
 CONFIG_REGULATOR_PWM=y
 CONFIG_REGULATOR_RK8XX=y
@@ -57,5 +64,4 @@ CONFIG_USB_ETHER_ASIX88179=y
 CONFIG_USB_ETHER_MCS7830=y
 CONFIG_USB_ETHER_RTL8152=y
 CONFIG_USB_ETHER_SMSC95XX=y
-CONFIG_SPL_TINY_MEMSET=y
 CONFIG_ERRNO_STR=y
-- 
2.43.2