[PATCH 22/31] rockchip: rk3399-firefly: Sync device tree from linux v6.8
Jonas Karlman
jonas at kwiboo.se
Sun Mar 31 22:28:28 CEST 2024
Sync rk3399-firefly device tree from linux v6.8.
Add AHCI=y, SCSI_AHCI=y, AHCI_PCI=y and SCSI=y to support PCIe SATA.
Change to SPL_MAX_SIZE=0x40000, SPL can be up to 256 KiB.
Add ROCKCHIP_IODOMAIN=y to configure io-domain voltage.
Add MMC_SDHCI_SDMA=y to use DMA transfer for eMMC.
Add PHY_REALTEK=y and DM_ETH_PHY=y to support ethernet PHY.
Add PHY_ROCKCHIP_INNO_USB2=y and PHY_ROCKCHIP_TYPEC=y to support USB PHY.
Remove SPL_TINY_MEMSET=y to use full memset in SPL.
Signed-off-by: Jonas Karlman <jonas at kwiboo.se>
---
arch/arm/dts/rk3399-firefly.dts | 17 ++++++++++++-----
configs/firefly-rk3399_defconfig | 13 +++++++++++--
2 files changed, 23 insertions(+), 7 deletions(-)
diff --git a/arch/arm/dts/rk3399-firefly.dts b/arch/arm/dts/rk3399-firefly.dts
index c4dd2a6b4836..260415d99aeb 100644
--- a/arch/arm/dts/rk3399-firefly.dts
+++ b/arch/arm/dts/rk3399-firefly.dts
@@ -5,6 +5,7 @@
/dts-v1/;
#include <dt-bindings/input/linux-event-codes.h>
+#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/pwm/pwm.h>
#include <dt-bindings/usb/pd.h>
#include "rk3399.dtsi"
@@ -15,6 +16,7 @@
compatible = "firefly,firefly-rk3399", "rockchip,rk3399";
aliases {
+ ethernet0 = &gmac;
mmc0 = &sdio0;
mmc1 = &sdmmc;
mmc2 = &sdhci;
@@ -86,7 +88,7 @@
pinctrl-names = "default";
pinctrl-0 = <&pwrbtn>;
- power {
+ key-power {
debounce-interval = <100>;
gpios = <&gpio0 RK_PA5 GPIO_ACTIVE_LOW>;
label = "GPIO Key Power";
@@ -245,12 +247,12 @@
vdd_log: vdd-log {
compatible = "pwm-regulator";
pwms = <&pwm2 0 25000 1>;
+ pwm-supply = <&vcc_sys>;
regulator-name = "vdd_log";
regulator-always-on;
regulator-boot-on;
regulator-min-microvolt = <430000>;
regulator-max-microvolt = <1400000>;
- vin-supply = <&vcc_sys>;
};
};
@@ -298,6 +300,11 @@
status = "okay";
};
+&gpu {
+ mali-supply = <&vdd_gpu>;
+ status = "okay";
+};
+
&hdmi {
ddc-i2c-bus = <&i2c3>;
pinctrl-names = "default";
@@ -770,8 +777,8 @@
sd-uhs-sdr104;
/* Power supply */
- vqmmc-supply = &vcc1v8_s3; /* IO line */
- vmmc-supply = &vcc_sdio; /* card's power */
+ vqmmc-supply = <&vcc1v8_s3>; /* IO line */
+ vmmc-supply = <&vcc_sdio>; /* card's power */
#address-cells = <1>;
#size-cells = <0>;
@@ -781,7 +788,7 @@
reg = <1>;
compatible = "brcm,bcm4329-fmac";
interrupt-parent = <&gpio0>;
- interrupts = <RK_PA3 GPIO_ACTIVE_HIGH>;
+ interrupts = <RK_PA3 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "host-wake";
brcm,drive-strength = <5>;
pinctrl-names = "default";
diff --git a/configs/firefly-rk3399_defconfig b/configs/firefly-rk3399_defconfig
index db98926b627a..2f81a2ed0da6 100644
--- a/configs/firefly-rk3399_defconfig
+++ b/configs/firefly-rk3399_defconfig
@@ -14,9 +14,10 @@ CONFIG_DEBUG_UART_CLOCK=24000000
CONFIG_SYS_LOAD_ADDR=0x800800
CONFIG_PCI=y
CONFIG_DEBUG_UART=y
+CONFIG_AHCI=y
CONFIG_DEFAULT_FDT_FILE="rockchip/rk3399-firefly.dtb"
CONFIG_DISPLAY_BOARDINFO_LATE=y
-CONFIG_SPL_MAX_SIZE=0x2e000
+CONFIG_SPL_MAX_SIZE=0x40000
CONFIG_SPL_PAD_TO=0x7f8000
# CONFIG_SPL_RAW_IMAGE_SUPPORT is not set
CONFIG_SPL_ATF_NO_PLATFORM_PARAM=y
@@ -32,19 +33,28 @@ CONFIG_SPL_OF_CONTROL=y
CONFIG_OF_SPL_REMOVE_PROPS="clock-names interrupt-parent assigned-clocks assigned-clock-rates assigned-clock-parents"
CONFIG_ENV_IS_IN_MMC=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
+CONFIG_SCSI_AHCI=y
+CONFIG_AHCI_PCI=y
CONFIG_ROCKCHIP_GPIO=y
CONFIG_SYS_I2C_ROCKCHIP=y
+CONFIG_ROCKCHIP_IODOMAIN=y
CONFIG_MMC_DW=y
CONFIG_MMC_DW_ROCKCHIP=y
CONFIG_MMC_SDHCI=y
+CONFIG_MMC_SDHCI_SDMA=y
CONFIG_MMC_SDHCI_ROCKCHIP=y
+CONFIG_PHY_REALTEK=y
+CONFIG_DM_ETH_PHY=y
CONFIG_ETH_DESIGNWARE=y
CONFIG_GMAC_ROCKCHIP=y
CONFIG_NVME_PCI=y
+CONFIG_PHY_ROCKCHIP_INNO_USB2=y
+CONFIG_PHY_ROCKCHIP_TYPEC=y
CONFIG_PMIC_RK8XX=y
CONFIG_REGULATOR_PWM=y
CONFIG_REGULATOR_RK8XX=y
CONFIG_PWM_ROCKCHIP=y
+CONFIG_SCSI=y
CONFIG_BAUDRATE=1500000
CONFIG_DEBUG_UART_SHIFT=2
CONFIG_SYS_NS16550_MEM32=y
@@ -61,5 +71,4 @@ CONFIG_USB_ETHER_ASIX88179=y
CONFIG_USB_ETHER_MCS7830=y
CONFIG_USB_ETHER_RTL8152=y
CONFIG_USB_ETHER_SMSC95XX=y
-CONFIG_SPL_TINY_MEMSET=y
CONFIG_ERRNO_STR=y
--
2.43.2
More information about the U-Boot
mailing list