[PATCH v2 1/2] doc: Detailed example for netconsole setup
Fiona Klute
fiona.klute at gmx.de
Thu May 16 12:42:44 CEST 2024
This adds details that I would have liked to have readily available,
in particular how to activate the network interface before enabling
netconsole, and how to integrate netconsole so you can use the U-Boot
prompt.
Signed-off-by: Fiona Klute <fiona.klute at gmx.de>
---
Changes in v2:
* Include stderr redirection
* Use 4 spaces instead of tabs for code block to avoid overflowing
lines
doc/usage/netconsole.rst | 33 ++++++++++++++++++++++++++++++++-
1 file changed, 32 insertions(+), 1 deletion(-)
diff --git a/doc/usage/netconsole.rst b/doc/usage/netconsole.rst
index 2aa3b9ccc5..647f0c220b 100644
--- a/doc/usage/netconsole.rst
+++ b/doc/usage/netconsole.rst
@@ -18,7 +18,9 @@ broadcast address and port 6666 are used. If it is set to an IP
address of 0 (or 0.0.0.0) then no messages are sent to the network.
The source / listening port can be configured separately by setting
the 'ncinport' environment variable and the destination port can be
-configured by setting the 'ncoutport' environment variable.
+configured by setting the 'ncoutport' environment variable. Note that
+you need to set up the network interface (e.g. using DHCP) before it
+can be used for network console.
For example, if your server IP is 192.168.1.1, you could use::
@@ -107,3 +109,32 @@ as follows:
Note that unlike the U-Boot implementation the Linux netconsole is
unidirectional, i. e. you have console output only in Linux.
+
+Setup via environment
+---------------------
+
+If persistent environment is enabled in your U-Boot configuration, you
+can configure the network console using the environment. For example::
+
+ => env set autoload no
+ => env set hostname "u-boot"
+ => env set bootdelay 5
+ => env set nc 'dhcp; env set stdout nc; env set stderr nc; env set stdin nc'
+ => env set ncip 192.168.1.1
+ => env set preboot "${preboot}; run nc;"
+ => env save
+ => reset
+
+``autoload no`` tells the ``dhcp`` command to configure the network
+interface without trying to load an image. ``hostname "u-boot"`` sets
+the hostname to be sent in DHCP requests, so they are easy to
+recognize in the DHCP server log. The command in ``nc`` calls ``dhcp``
+to make sure the network interface is set up before enabling
+netconsole.
+
+Adding ``nc`` to ``preboot`` tells U-Boot to activate netconsole
+before trying to find any boot options, so you can interact with it if
+desired.
+
+``env save`` stores the settings persistently, and ``reset`` then
+triggers a fresh start that will use the changed settings.
--
2.43.0
More information about the U-Boot
mailing list