[RESEND PATCH v4 1/3] mmc: use an enumerated type to represent PARTITION_CONFIG fields
Tim Harvey
tharvey at gateworks.com
Fri May 31 17:36:33 CEST 2024
Modern eMMC v4+ devices have multiple hardware partitions per the JEDEC
specification described as:
Boot Area Partition 1
Boot Area Partition 2
RPMB Partition
General Purpose Partition 1
General Purpose Partition 2
General Purpose Partition 3
General Purpose Partition 4
User Data Area
These are referenced by fields in the PARTITION_CONFIG register
(Extended CSD Register 179) which is defined as:
bit 7: reserved
bit 6: BOOT_ACK
0x0: No boot acknowledge sent (default
0x1: Boot acknowledge sent during boot operation Bit
bit 5:3: BOOT_PARTITION_ENABLE
0x0: Device not boot enabled (default)
0x1: Boot Area partition 1 enabled for boot
0x2: Boot Area partition 2 enabled for boot
0x3-0x6: Reserved
0x7: User area enabled for boot
bit 2:0 PARTITION_ACCESS
0x0: No access to boot partition (default)
0x1: Boot Area partition 1
0x2: Boot Area partition 2
0x3: Replay Protected Memory Block (RPMB)
0x4: Access to General Purpose partition 1
0x5: Access to General Purpose partition 2
0x6: Access to General Purpose partition 3
0x7: Access to General Purpose partition 4
Note that setting PARTITION_ACCESS to 0x0 results in selecting the User
Data Area partition.
You can see above that the two fields BOOT_PARTITION_ENABLE and
PARTITION_ACCESS do not use the same enumerated values.
U-Boot uses a set of macros to access fields of the PARTITION_CONFIG
register:
There are various places in U-Boot where the BOOT_PARTITION_ENABLE field
is accessed via EXT_CSD_EXTRACT_PARTITION_ACCESS and converted to a
hardware partition consistent with the definition of the
PARTITION_ACCESS field which is also the value used to specify the
hardware partition of the various mmc_switch incarnations.
To add some sanity to the distinction between BOOT_PARTITION_ENABLE
(used to specify the active device on power-cycle) and PARTITION_ACCESS
(used to switch between hardware partitions) create two enumerated types
and use them wherever struct mmc * part_config is used or the above
macros are used.
This represents no code changes.
Signed-off-by: Tim Harvey <tharvey at gateworks.com>
---
v4: new patch (split to series)
---
arch/arm/mach-imx/image-container.c | 10 +++++-----
arch/arm/mach-sunxi/board.c | 2 +-
board/gateworks/venice/spl.c | 4 ++--
board/gateworks/venice/venice.c | 22 +++++++++++-----------
board/purism/librem5/librem5.c | 4 ++--
board/storopack/smegw01/smegw01.c | 4 ++--
cmd/mvebu/bubt.c | 4 ++--
common/spl/spl_mmc.c | 4 ++--
include/mmc.h | 20 ++++++++++++++++++++
9 files changed, 47 insertions(+), 27 deletions(-)
diff --git a/arch/arm/mach-imx/image-container.c b/arch/arm/mach-imx/image-container.c
index 35da0ae04258..bcd40889f0fa 100644
--- a/arch/arm/mach-imx/image-container.c
+++ b/arch/arm/mach-imx/image-container.c
@@ -205,7 +205,7 @@ static unsigned long get_boot_device_offset(void *dev, int dev_type)
} else {
u8 part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
- if (part == 1 || part == 2) {
+ if (part == EMMC_BOOT_PART_BOOT1 || part == EMMC_BOOT_PART_BOOT2) {
if (is_imx8qxp() && is_soc_rev(CHIP_REV_B))
offset = CONTAINER_HDR_MMCSD_OFFSET;
else
@@ -294,15 +294,15 @@ int spl_mmc_emmc_boot_partition(struct mmc *mmc)
int part;
part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
- if (part == 1 || part == 2) {
+ if (part == EMMC_BOOT_PART_BOOT1 || part == EMMC_BOOT_PART_BOOT2) {
unsigned long sec_set_off = 0;
bool sec_boot = false;
sec_boot = check_secondary_cnt_set(&sec_set_off);
if (sec_boot)
- part = (part == 1) ? 2 : 1;
- } else if (part == 7) {
- part = 0;
+ part = (part == EMMC_BOOT_PART_BOOT1) ? EMMC_HWPART_BOOT2 : EMMC_HWPART_BOOT1;
+ } else if (part == EMMC_BOOT_PART_USER) {
+ part = EMMC_HWPART_DEFAULT;
}
return part;
diff --git a/arch/arm/mach-sunxi/board.c b/arch/arm/mach-sunxi/board.c
index 0140b07d32a6..860e7058b69c 100644
--- a/arch/arm/mach-sunxi/board.c
+++ b/arch/arm/mach-sunxi/board.c
@@ -396,7 +396,7 @@ static bool sunxi_valid_emmc_boot(struct mmc *mmc)
return false;
/* Partition 0 is the user data partition, bootpart must be 1 or 2. */
- if (bootpart != 1 && bootpart != 2)
+ if (bootpart != EMMC_BOOT_PART_BOOT1 && bootpart != EMMC_BOOT_PART_BOOT2)
return false;
/* Failure to switch to the boot partition is fatal. */
diff --git a/board/gateworks/venice/spl.c b/board/gateworks/venice/spl.c
index 3b0f11f2fd0f..6f6dea84feee 100644
--- a/board/gateworks/venice/spl.c
+++ b/board/gateworks/venice/spl.c
@@ -353,8 +353,8 @@ unsigned long board_spl_mmc_get_uboot_raw_sector(struct mmc *mmc, unsigned long
{
if (!IS_SD(mmc)) {
switch (EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config)) {
- case 1:
- case 2:
+ case EMMC_BOOT_PART_BOOT1:
+ case EMMC_BOOT_PART_BOOT2:
if (IS_ENABLED(CONFIG_IMX8MN) || IS_ENABLED(CONFIG_IMX8MP))
raw_sect -= 32 * 2;
break;
diff --git a/board/gateworks/venice/venice.c b/board/gateworks/venice/venice.c
index 5b105d7659e4..44ed4e4598e1 100644
--- a/board/gateworks/venice/venice.c
+++ b/board/gateworks/venice/venice.c
@@ -173,20 +173,20 @@ int board_late_init(void)
int bootpart;
switch (EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config)) {
- case 1: /* boot0 */
- bootpart = 1;
+ case EMMC_BOOT_PART_BOOT1:
+ bootpart = EMMC_HWPART_BOOT1;
break;
- case 2: /* boot1 */
- bootpart = 2;
+ case EMMC_BOOT_PART_BOOT2:
+ bootpart = EMMC_HWPART_BOOT2;
break;
- case 7: /* user */
+ case EMMC_BOOT_PART_USER:
default:
- bootpart = 0;
+ bootpart = EMMC_HWPART_DEFAULT;
break;
}
/* IMX8MP/IMX8MN BOOTROM v2 uses offset=0 for boot parts */
if ((IS_ENABLED(CONFIG_IMX8MN) || IS_ENABLED(CONFIG_IMX8MP)) &&
- (bootpart == 1 || bootpart == 2))
+ (bootpart == EMMC_BOOT_PART_BOOT1 || bootpart == EMMC_BOOT_PART_BOOT2))
bootblk = 0;
env_set_hex("bootpart", bootpart);
env_set_hex("bootblk", bootblk);
@@ -217,10 +217,10 @@ uint mmc_get_env_part(struct mmc *mmc)
{
if (!IS_SD(mmc)) {
switch (EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config)) {
- case 1:
- return 1;
- case 2:
- return 2;
+ case EMMC_BOOT_PART_BOOT1:
+ return EMMC_HWPART_BOOT1;
+ case EMMC_BOOT_PART_BOOT2:
+ return EMMC_HWPART_BOOT2;
}
}
diff --git a/board/purism/librem5/librem5.c b/board/purism/librem5/librem5.c
index d0249e71f09a..3f1a8e385d72 100644
--- a/board/purism/librem5/librem5.c
+++ b/board/purism/librem5/librem5.c
@@ -43,8 +43,8 @@ uint board_mmc_get_env_part(struct mmc *mmc)
{
uint part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
- if (part == 7)
- part = 0;
+ if (part == EMMC_BOOT_PART_USER)
+ part = EMMC_HWPART_DEFAULT;
return part;
}
#endif
diff --git a/board/storopack/smegw01/smegw01.c b/board/storopack/smegw01/smegw01.c
index 345191b31c29..d1f474bc7a14 100644
--- a/board/storopack/smegw01/smegw01.c
+++ b/board/storopack/smegw01/smegw01.c
@@ -106,8 +106,8 @@ uint mmc_get_env_part(struct mmc *mmc)
{
uint part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
- if (part == 7)
- part = 0;
+ if (part == EMMC_BOOT_PART_USER)
+ part = EMMC_HWPART_DEFAULT;
return part;
}
diff --git a/cmd/mvebu/bubt.c b/cmd/mvebu/bubt.c
index 744b1c20aa83..1e3f5bf7add6 100644
--- a/cmd/mvebu/bubt.c
+++ b/cmd/mvebu/bubt.c
@@ -224,8 +224,8 @@ static int mmc_burn_image(size_t image_size)
#endif
part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
- if (part == 7)
- part = 0;
+ if (part == EMMC_BOOT_PART_USER)
+ part = EMMC_HWPART_DEFAULT;
#ifdef CONFIG_BLK
err = blk_dselect_hwpart(blk_desc, part);
diff --git a/common/spl/spl_mmc.c b/common/spl/spl_mmc.c
index 3d032bb27ce3..fd5154dad7c4 100644
--- a/common/spl/spl_mmc.c
+++ b/common/spl/spl_mmc.c
@@ -320,8 +320,8 @@ int default_spl_mmc_emmc_boot_partition(struct mmc *mmc)
* which is the first physical partition (0).
*/
part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
- if (part == 7)
- part = 0;
+ if (part == EMMC_BOOT_PART_USER)
+ part = EMMC_HWPART_DEFAULT;
#endif
return part;
}
diff --git a/include/mmc.h b/include/mmc.h
index 4b8327f1f93b..0f3f1ed6aaa3 100644
--- a/include/mmc.h
+++ b/include/mmc.h
@@ -381,6 +381,26 @@ enum mmc_voltage {
#define MMC_TIMING_MMC_HS200 9
#define MMC_TIMING_MMC_HS400 10
+/* emmc PARTITION_CONFIG BOOT_PARTITION_ENABLE values */
+enum emmc_boot_part {
+ EMMC_BOOT_PART_DEFAULT = 0,
+ EMMC_BOOT_PART_BOOT1 = 1,
+ EMMC_BOOT_PART_BOOT2 = 2,
+ EMMC_BOOT_PART_USER = 7,
+};
+
+/* emmc PARTITION_CONFIG ACCESS_ENABLE values */
+enum emmc_hwpart {
+ EMMC_HWPART_DEFAULT = 0, /* user */
+ EMMC_HWPART_BOOT1 = 1,
+ EMMC_HWPART_BOOT2 = 2,
+ EMMC_HWPART_RPMB = 3,
+ EMMC_HWPART_GP1 = 4,
+ EMMC_HWPART_GP2 = 5,
+ EMMC_HWPART_GP3 = 6,
+ EMMC_HWPART_GP4 = 7,
+};
+
/* Driver model support */
/**
--
2.25.1
More information about the U-Boot
mailing list