[PATCH 1/6] arm: dts: k3-j7200-r5: Add the pmic node in R5 dt

Limaye, Aniket a-limaye at ti.com
Fri May 31 18:54:30 CEST 2024



On 5/31/2024 7:25 PM, Kumar, Udit wrote:
> 
> On 5/31/2024 6:38 PM, Aniket Limaye wrote:
>> Add bootph-pre-ram property to the buck node in the pmic needed for
>> ESM error event handling.
>>
>> Signed-off-by: Aniket Limaye <a-limaye at ti.com>
>> ---
>>   arch/arm/dts/k3-j7200-r5-common-proc-board.dts | 9 +++++++++
>>   1 file changed, 9 insertions(+)
>>
>> diff --git a/arch/arm/dts/k3-j7200-r5-common-proc-board.dts 
>> b/arch/arm/dts/k3-j7200-r5-common-proc-board.dts
>> index fb7e2e50239..78d07ff4e70 100644
>> --- a/arch/arm/dts/k3-j7200-r5-common-proc-board.dts
>> +++ b/arch/arm/dts/k3-j7200-r5-common-proc-board.dts
>> @@ -96,3 +96,12 @@
>>   &mcu_udmap {
>>       ti,sci = <&dm_tifs>;
>>   };
>> +
>> +&tps659414 {
>> +    regulators {
>> +        bucka1: buck1 {
>> +            bootph-pre-ram;
>> +        };
> 
> 
> why not to add this in kernel DT

Manorit has already posted a series to kernel to add bootph- properties 
across platforms... Specifically the patch here [0] addresses this.

Once that is merged, and goes through the rebasing tree in u-boot we 
will need to send patches to remove the bootph properties from the 
-u-boot and -r5 files. Until then we need this patch for the ESM to 
work. Else we can wait till the kernel dt patches make it through to 
u-boot for me to roll out a v2.

[0]: 
https://lore.kernel.org/all/20240507-b4-upstream-bootph-all-v1-5-c6d52651856f@ti.com/

> 
> 
>> +    };
>> +};
>> +


More information about the U-Boot mailing list