[PATCH v11 06/29] test: boot: fix bootflow_cmd_label for when DSA_SANDBOX is disabled

[Jerome Forissier]

When DSA_SANDBOX is not set, the sandbox tests fail as follows:

 $ ./test/py/test.py --build-dir=$(pwd) -k bootdev_test_any
 [...]
 Scanning for bootflows with label '9'
 [...]
 Cannot find '9' (err=-19)

This is due to the device list containing two less entries than
expected. Therefore, look for label '7' when DSA_SANDBOX is disabled.

The actual use case is NET_LWIP=y (to be introduced in later patches)
which implies DSA_SANDBOX=n for the time being.

Signed-off-by: Jerome Forissier <jerome.forissier at linaro.org>
---
 test/boot/bootflow.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/test/boot/bootflow.c b/test/boot/bootflow.c
index 6ad63afe90a..c440b8eb778 100644
--- a/test/boot/bootflow.c
+++ b/test/boot/bootflow.c
@@ -109,9 +109,12 @@ static int bootflow_cmd_label(struct unit_test_state *uts)
 	 * 8   [   ]      OK  mmc       mmc2.bootdev
 	 * 9   [ + ]      OK  mmc       mmc1.bootdev
 	 * a   [   ]      OK  mmc       mmc0.bootdev
+	 *
+	 * However with CONFIG_DSA_SANDBOX=n we have two less (dsa-test at 0 and
+	 * dsa-test at 1).
 	 */
-	ut_assertok(run_command("bootflow scan -lH 9", 0));
-	ut_assert_nextline("Scanning for bootflows with label '9'");
+	ut_assertok(run_command("bootflow scan -lH 7", 0));
+	ut_assert_nextline("Scanning for bootflows with label '7'");
 	ut_assert_skip_to_line("(1 bootflow, 1 valid)");
 
 	ut_assertok(run_command("bootflow scan -lH 0", 0));
-- 
2.40.1