[PATCH v12 0/9] spi-nor: Add parallel and stacked memories support

[Venkatesh Yadav Abbarapu]

This series adds support for Xilinx qspi parallel and
stacked memeories.

In parallel mode, the current implementation assumes that a maximum
of two flashes are connected. The QSPI controller splits the data
evenly between both the flashes so, both the flashes that are connected
in parallel mode should be identical.
During each operation SPI-NOR sets 0th bit for CS0 & 1st bit for CS1 in
nor->flags.

In stacked mode the current implementation assumes that a maximum of two
flashes are connected and both the flashes are of same make but can differ
in sizes. So, except the sizes all other flash parameters of both the flashes
are identical.

Spi-nor will pass on the appropriate flash select flag to low level driver,
and it will select pass all the data to that particular flash.

Write operation in parallel mode are performed in page size * 2 chunks as
each write operation results in writing both the flashes. For doubling the
address space each operation is performed at addr/2 flash offset, where addr
is the address specified by the user.

Similarly for read and erase operations it will read from both flashes, so
size and offset are divided by 2 and send to flash.

Changes in v2:
- Fixed the compilation issues.
Changes in v3:
- Fixed the CI issues.
Changes in v4:
- Removed the dio,dummy_bytes variables from zynq_qspi driver.
- Fix the compilation issue by including the DM_SPI config.
Changes in v5:
- Fixed the issue reported by buildman.
Changes in v6:
- Fixed the issues reported while running the sandbox test cases.
Changes in v7:
- Fixed the issues reported while running these da850evm_defconfig,
  imx28_xea_defconfig configs.
- Fixed the issue when DM_SPI config is disabled.
- Fixed the issue while running the sandbox_noinst_defconfig with spl
  ./spl/u-boot-spl -d arch/sandbox/dts/test.dtb
   jedec_spi_nor spi.bin at 0: has no valid 'reg' property (-12)
   jedec_spi_nor spi.bin at 1: has no valid 'reg' property (-12)
   ### ERROR ### Please RESET the board ### Changes in v8:
- Fixed the compilation issue with imx28_xea_defconfig.
- Fixed the SPL size issue with the axm and taurus defconfigs.
- Rebased the patches on top of next branch.
Changes in v9:
- Updated the commit log why SPL_FIT is being enabled.
Changes in v10:
- Added the new config SPI_ADVANCE to fix the issue while enabling imx28_xea_defconfig.
Changes in v11:
- Removed the unused variable, corrected the type of variable and replaced memcpy with memmove.
Changes in v12:
- Fixed the compilation issue with mx6sabresd defconfig, as the binary size got exceeded.

Ashok Reddy Soma (2):
  mtd: spi-nor: Add parallel memories support for read_sr and read_fsr
  mtd: spi-nor: Add parallel and stacked memories support in read_bar
    and write_bar

Venkatesh Yadav Abbarapu (7):
  mtd: spi-nor: Add parallel and stacked memories support
  spi: spi-uclass: Read chipselect and restrict capabilities
  spi: zynqmp_gqspi: Add parallel memories support in GQSPI driver
  spi: zynq_qspi: Add parallel memories support in QSPI driver
  spi: Add the spi advance options for non SPL
  config: xea: Enable the SPI_ADVANCE config option
  config: mx6sabresd: Default don't enable the flash lock

 configs/imx28_xea_defconfig    |   1 +
 configs/mx6sabresd_defconfig   |   1 +
 drivers/mtd/spi/sandbox.c      |   2 +-
 drivers/mtd/spi/spi-nor-core.c | 400 ++++++++++++++++++++++++++++-----
 drivers/spi/Kconfig            |   8 +
 drivers/spi/altera_spi.c       |   4 +-
 drivers/spi/atcspi200_spi.c    |   2 +-
 drivers/spi/ath79_spi.c        |   2 +-
 drivers/spi/atmel_spi.c        |   6 +-
 drivers/spi/bcm63xx_hsspi.c    |  42 ++--
 drivers/spi/bcm63xx_spi.c      |   6 +-
 drivers/spi/bcmbca_hsspi.c     |  34 +--
 drivers/spi/cf_spi.c           |   6 +-
 drivers/spi/davinci_spi.c      |   8 +-
 drivers/spi/fsl_dspi.c         |  18 +-
 drivers/spi/fsl_espi.c         |   4 +-
 drivers/spi/fsl_qspi.c         |   4 +-
 drivers/spi/gxp_spi.c          |   2 +-
 drivers/spi/mpc8xx_spi.c       |   4 +-
 drivers/spi/mpc8xxx_spi.c      |  10 +-
 drivers/spi/mscc_bb_spi.c      |   4 +-
 drivers/spi/mxc_spi.c          |   6 +-
 drivers/spi/npcm_fiu_spi.c     |  14 +-
 drivers/spi/nxp_fspi.c         |   2 +-
 drivers/spi/octeon_spi.c       |   2 +-
 drivers/spi/omap3_spi.c        |   4 +-
 drivers/spi/pic32_spi.c        |   2 +-
 drivers/spi/rk_spi.c           |   4 +-
 drivers/spi/rockchip_sfc.c     |   2 +-
 drivers/spi/spi-aspeed-smc.c   |  28 +--
 drivers/spi/spi-mxic.c         |   6 +-
 drivers/spi/spi-qup.c          |   4 +-
 drivers/spi/spi-sifive.c       |   6 +-
 drivers/spi/spi-sn-f-ospi.c    |   2 +-
 drivers/spi/spi-sunxi.c        |   6 +-
 drivers/spi/spi-synquacer.c    |   4 +-
 drivers/spi/spi-uclass.c       |  34 ++-
 drivers/spi/stm32_qspi.c       |   2 +-
 drivers/spi/stm32_spi.c        |   4 +-
 drivers/spi/ti_qspi.c          |  14 +-
 drivers/spi/xilinx_spi.c       |   6 +-
 drivers/spi/zynq_qspi.c        | 121 ++++++++--
 drivers/spi/zynq_spi.c         |   6 +-
 drivers/spi/zynqmp_gqspi.c     | 141 ++++++++++--
 include/linux/mtd/spi-nor.h    |  12 +
 include/spi.h                  |  23 +-
 lib/acpi/acpi_device.c         |   2 +-
 47 files changed, 794 insertions(+), 231 deletions(-)

-- 
2.17.1