[PATCH 09/13] ufs: Sync possible UFS Quirks with Linux UFS driver

[neil.armstrong at linaro.org]

From: Bhupesh Sharma <bhupesh.linux at gmail.com>

Sync u-boot UFS driver to add all possible UFS Quirks
as supported by Linux UFS driver as well.

Signed-off-by: Bhupesh Sharma <bhupesh.sharma at linaro.org>
---
 drivers/ufs/ufs.h | 151 +++++++++++++++++++++++++++++++++++++++++++-----------
 1 file changed, 120 insertions(+), 31 deletions(-)

diff --git a/drivers/ufs/ufs.h b/drivers/ufs/ufs.h
index 555f8a6857d..e8a14411560 100644
--- a/drivers/ufs/ufs.h
+++ b/drivers/ufs/ufs.h
@@ -712,38 +712,127 @@ struct ufs_hba {
 	u32			version;
 	u32			intr_mask;
 	u32			quirks;
-/*
- * If UFS host controller is having issue in processing LCC (Line
- * Control Command) coming from device then enable this quirk.
- * When this quirk is enabled, host controller driver should disable
- * the LCC transmission on UFS device (by clearing TX_LCC_ENABLE
- * attribute of device to 0).
- */
-#define UFSHCD_QUIRK_BROKEN_LCC				BIT(0)
 
-/*
- * This quirk needs to be enabled if the host controller has
- * 64-bit addressing supported capability but it doesn't work.
- */
-#define UFSHCD_QUIRK_BROKEN_64BIT_ADDRESS		BIT(1)
-
-/*
- * This quirk needs to be enabled if the host controller has
- * auto-hibernate capability but it's FASTAUTO only.
- */
-#define UFSHCD_QUIRK_HIBERN_FASTAUTO			BIT(2)
-
-/*
- * This quirk needs to be enabled if the host controller has
- * 64-bit addressing supported capability but it doesn't work.
- */
-#define UFSHCD_QUIRK_BROKEN_64BIT_ADDRESS		0x2
-
-/*
- * This quirk needs to be enabled if the host controller has
- * auto-hibernate capability but it's FASTAUTO only.
- */
-#define UFSHCD_QUIRK_HIBERN_FASTAUTO			0x4
+	/* Interrupt aggregation support is broken */
+#define UFSHCD_QUIRK_BROKEN_INTR_AGGR		(1 << 0)
+
+	/*
+	 * delay before each dme command is required as the unipro
+	 * layer has shown instabilities
+	 */
+#define UFSHCD_QUIRK_DELAY_BEFORE_DME_CMDS	(1 << 1)
+
+	/*
+	 * If UFS host controller is having issue in processing LCC (Line
+	 * Control Command) coming from device then enable this quirk.
+	 * When this quirk is enabled, host controller driver should disable
+	 * the LCC transmission on UFS device (by clearing TX_LCC_ENABLE
+	 * attribute of device to 0).
+	 */
+#define UFSHCD_QUIRK_BROKEN_LCC			(1 << 2)
+
+	/*
+	 * The attribute PA_RXHSUNTERMCAP specifies whether or not the
+	 * inbound Link supports unterminated line in HS mode. Setting this
+	 * attribute to 1 fixes moving to HS gear.
+	 */
+#define UFSHCD_QUIRK_BROKEN_PA_RXHSUNTERMCAP	(1 << 3)
+
+	/*
+	 * This quirk needs to be enabled if the host controller only allows
+	 * accessing the peer dme attributes in AUTO mode (FAST AUTO or
+	 * SLOW AUTO).
+	 */
+#define UFSHCD_QUIRK_DME_PEER_ACCESS_AUTO_MODE	(1 << 4)
+
+	/*
+	 * This quirk needs to be enabled if the host controller doesn't
+	 * advertise the correct version in UFS_VER register. If this quirk
+	 * is enabled, standard UFS host driver will call the vendor specific
+	 * ops (get_ufs_hci_version) to get the correct version.
+	 */
+#define UFSHCD_QUIRK_BROKEN_UFS_HCI_VERSION	(1 << 5)
+
+	/*
+	 * Clear handling for transfer/task request list is just opposite.
+	 */
+#define UFSHCI_QUIRK_BROKEN_REQ_LIST_CLR	(1 << 6)
+
+	/*
+	 * This quirk needs to be enabled if host controller doesn't allow
+	 * that the interrupt aggregation timer and counter are reset by s/w.
+	 */
+#define UFSHCI_QUIRK_SKIP_RESET_INTR_AGGR	(1 << 7)
+
+	/*
+	 * This quirks needs to be enabled if host controller cannot be
+	 * enabled via HCE register.
+	 */
+#define UFSHCI_QUIRK_BROKEN_HCE			(1 << 8)
+
+	/*
+	 * This quirk needs to be enabled if the host controller regards
+	 * resolution of the values of PRDTO and PRDTL in UTRD as byte.
+	 */
+#define UFSHCD_QUIRK_PRDT_BYTE_GRAN		(1 << 9)
+
+	/*
+	 * This quirk needs to be enabled if the host controller reports
+	 * OCS FATAL ERROR with device error through sense data
+	 */
+#define UFSHCD_QUIRK_BROKEN_OCS_FATAL_ERROR	(1 << 10)
+
+	/*
+	 * This quirk needs to be enabled if the host controller has
+	 * auto-hibernate capability but it doesn't work.
+	 */
+#define UFSHCD_QUIRK_BROKEN_AUTO_HIBERN8	(1 << 11)
+
+	/*
+	 * This quirk needs to disable manual flush for write booster
+	 */
+#define UFSHCI_QUIRK_SKIP_MANUAL_WB_FLUSH_CTRL	(1 << 12)
+
+	/*
+	 * This quirk needs to disable unipro timeout values
+	 * before power mode change
+	 */
+#define UFSHCD_QUIRK_SKIP_DEF_UNIPRO_TIMEOUT_SETTING	(1 << 13)
+
+	/*
+	 * Align DMA SG entries on a 4 KiB boundary.
+	 */
+#define UFSHCD_QUIRK_4KB_DMA_ALIGNMENT			(1 << 14)
+
+	/*
+	 * This quirk needs to be enabled if the host controller does not
+	 * support UIC command
+	 */
+#define UFSHCD_QUIRK_BROKEN_UIC_CMD			(1 << 15)
+
+	/*
+	 * This quirk needs to be enabled if the host controller cannot
+	 * support physical host configuration.
+	 */
+#define UFSHCD_QUIRK_SKIP_PH_CONFIGURATION		(1 << 16)
+
+	/*
+	 * This quirk needs to be enabled if the host controller has
+	 * 64-bit addressing supported capability but it doesn't work.
+	 */
+#define UFSHCD_QUIRK_BROKEN_64BIT_ADDRESS		(1 << 17)
+
+	/*
+	 * This quirk needs to be enabled if the host controller has
+	 * auto-hibernate capability but it's FASTAUTO only.
+	 */
+#define UFSHCD_QUIRK_HIBERN_FASTAUTO			(1 << 18)
+
+	/*
+	 * This quirk needs to be enabled if the host controller needs
+	 * to reinit the device after switching to maximum gear.
+	 */
+#define UFSHCD_QUIRK_REINIT_AFTER_MAX_GEAR_SWITCH	(1 << 19)
 
 	/* Virtual memory reference */
 	struct utp_transfer_cmd_desc *ucdl;

-- 
2.34.1