[PATCH 19/27] mx23_olinuxino: Drop status-LED code

[Marek Vasut]

On 9/27/24 12:10 AM, Simon Glass wrote:
> Hi Marek,

Hello Simon,

> On Thu, 26 Sept 2024 at 23:40, Marek Vasut <marex at denx.de> wrote:
>>
>> On 9/26/24 10:44 PM, Simon Glass wrote:
>>> This is not used anymore, so drop it.
>>>
>>> Signed-off-by: Simon Glass <sjg at chromium.org>
>>> ---
>>>
>>>    board/olimex/mx23_olinuxino/mx23_olinuxino.c | 7 -------
>>>    1 file changed, 7 deletions(-)
>>>
>>> diff --git a/board/olimex/mx23_olinuxino/mx23_olinuxino.c b/board/olimex/mx23_olinuxino/mx23_olinuxino.c
>>> index b2bb6678c23..78136c1620a 100644
>>> --- a/board/olimex/mx23_olinuxino/mx23_olinuxino.c
>>> +++ b/board/olimex/mx23_olinuxino/mx23_olinuxino.c
>>> @@ -13,9 +13,6 @@
>>>    #include <asm/arch/imx-regs.h>
>>>    #include <asm/arch/clock.h>
>>>    #include <asm/arch/sys_proto.h>
>>> -#ifdef CONFIG_LED_STATUS
>>> -#include <status_led.h>
>>> -#endif
>>>    #include <linux/delay.h>
>>>
>>>    DECLARE_GLOBAL_DATA_PTR;
>>> @@ -61,9 +58,5 @@ int board_init(void)
>>>        /* Adress of boot parameters */
>>>        gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100;
>>>
>>> -#if defined(CONFIG_LED_STATUS) && defined(CONFIG_LED_STATUS_BOOT_ENABLE)
>>> -     status_led_set(CONFIG_LED_STATUS_BOOT, CONFIG_LED_STATUS_STATE);
>>> -#endif
>> Why not define the GPIO LED in DT, it might even already be defined there.
> 
> Yes I see it in the DT for quite a few boards, so that's what we should use.
Since LED uclass already uses well established DM_FLAG_PROBE_AFTER_BIND 
flag, the update here should be only a matter of enabling DM LED and 
GPIO LED driver.