[PATCH 07/10] include: env: phytec: k3_mmc: Use PHYTEC_K3_EMBED_RAUC_ENV to enable RAUC

[Daniel Schultz]

There's no need to include RAUC logic if it isn't required.
Use CONFIG_PHYTEC_K3_EMBED_RAUC_ENV to conditionally include RAUC.
Additionally, include the test for raucboot only when this
configuration is enabled.

Signed-off-by: Daniel Schultz <d.schultz at phytec.de>
---
 include/env/phytec/k3_mmc.env | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/include/env/phytec/k3_mmc.env b/include/env/phytec/k3_mmc.env
index ad8d3a8b764..c4354fbb884 100644
--- a/include/env/phytec/k3_mmc.env
+++ b/include/env/phytec/k3_mmc.env
@@ -7,13 +7,19 @@
 /* Logic for TI K3 based SoCs to boot from a MMC device. */
 
 #include <env/phytec/overlays.env>
+#ifdef CONFIG_PHYTEC_K3_EMBED_RAUC_ENV
 #include <env/phytec/rauc.env>
+doraucboot=1
+#endif
 
 mmcargs=setenv bootargs console=${console} earlycon=${earlycon}
 	root=/dev/mmcblk${mmcdev}p${mmcroot} ${raucargs} rootwait rw
 mmcloadimage=load mmc ${mmcdev}:${mmcpart} ${kernel_addr_r} Image
 mmcloadfdt=load mmc ${mmcdev}:${mmcpart} ${fdt_addr_r} ${fdtfile}
-mmcboot=if test ${doraucboot} = 1; then run raucinit; fi;
+mmcboot=
+#ifdef CONFIG_PHYTEC_K3_EMBED_RAUC_ENV
+	if test -n ${doraucboot}; then run raucinit; fi;
+#endif
 	run mmcargs;
 	mmc dev ${mmcdev};
 	mmc rescan;
-- 
2.25.1