[PATCH] board: kobol: helios4: enable ddr odt0 on write for both chip-select

[Josua Mayer]

Enabling ODT is required to suppress reflection of the data signal on
DDR write operation. SolidRun Armada 388 SoM only connects M_ODT[0] even
when both chip-select are used.

Enable ODT[0] for both chip-select during write only.

See also commit d09f199097d3 ("board: solidrun: clearfog: enable ddr odt0
on write for both chip-select") where this was added to SolidRun
Clearfog board which is using the same System on Module but unlike
Helios-4 without ECC memory.

Signed-off-by: Josua Mayer <josua at solid-run.com>
---
 board/kobol/helios4/helios4.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/board/kobol/helios4/helios4.c b/board/kobol/helios4/helios4.c
index 4c8407bb676846dda2a1270d53a07b0df5a1d13a..7714076edf1a84fdb68d90f134273d06fa7eff3b 100644
--- a/board/kobol/helios4/helios4.c
+++ b/board/kobol/helios4/helios4.c
@@ -73,7 +73,11 @@ static struct mv_ddr_topology_map board_topology_map = {
 	MV_DDR_CFG_DEFAULT,		/* ddr configuration data source */
 	NOT_COMBINED,			/* ddr twin-die combined */
 	{ {0} },			/* raw spd data */
-	{0}				/* timing parameters */
+	{0},				/* timing parameters */
+	{ {0} },			/* electrical configuration */
+	{0,},				/* electrical parameters */
+	0x30000,			/* ODT configuration */
+	0x3,				/* clock enable mask */
 };
 
 struct mv_ddr_topology_map *mv_ddr_topology_map_get(void)

---
base-commit: 6d41f0a39d6423c8e57e92ebbe9f8c0333a63f72
change-id: 20250207-a388-sr-som-odt-2-bd250cdd68bd

Best regards,
-- 
Josua Mayer <josua at solid-run.com>