[PATCH] gpio: x86: Correct usage of IS_ENABLED() macro in intel_pinctrl_defs.h

[Tom Rini]

This file was using IS_ENABLED() to test for CONFIG flags but omitted
the CONFIG_ prefix and so did not work as expected.

Signed-off-by: Tom Rini <trini at konsulko.com>
---
Cc: Simon Glass <sjg at chromium.org>
Cc: Bin Meng <bmeng.cn at gmail.com>
---
 arch/x86/include/asm/intel_pinctrl_defs.h | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/x86/include/asm/intel_pinctrl_defs.h b/arch/x86/include/asm/intel_pinctrl_defs.h
index 5d83d24bae2d..f45c06076f57 100644
--- a/arch/x86/include/asm/intel_pinctrl_defs.h
+++ b/arch/x86/include/asm/intel_pinctrl_defs.h
@@ -133,7 +133,7 @@
 #define PAD_CFG2_DEBOUNCE_MASK		0x1f
 
 /* voltage tolerance  0=3.3V default 1=1.8V tolerant */
-#if IS_ENABLED(INTEL_PINCTRL_IOSTANDBY)
+#if IS_ENABLED(CONFIG_INTEL_PINCTRL_IOSTANDBY)
 #define PAD_CFG1_TOL_MASK		(0x1 << 25)
 #define  PAD_CFG1_TOL_1V8		(0x1 << 25)
 #endif
@@ -150,7 +150,7 @@
 				PAD_CFG0_TRIG_##trig | \
 				PAD_CFG0_RX_POL_##inv)
 
-#if IS_ENABLED(INTEL_PINCTRL_DUAL_ROUTE_SUPPORT)
+#if IS_ENABLED(CONFIG_INTEL_PINCTRL_DUAL_ROUTE_SUPPORT)
 #define PAD_IRQ_CFG_DUAL_ROUTE(route1, route2, trig, inv)  \
 				(PAD_CFG0_ROUTE_##route1 | \
 				PAD_CFG0_ROUTE_##route2 | \
@@ -354,7 +354,7 @@
 		PAD_IRQ_CFG(NMI, trig, inv), PAD_PULL(pull) | \
 		PAD_IOSSTATE(TXD_RXE))
 
-#if IS_ENABLED(INTEL_PINCTRL_DUAL_ROUTE_SUPPORT)
+#if IS_ENABLED(CONFIG_INTEL_PINCTRL_DUAL_ROUTE_SUPPORT)
 /* GPI, GPIO Driver, SCI interrupt */
 #define PAD_CFG_GPI_GPIO_DRIVER_SCI(pad, pull, rst, trig, inv)	\
 	_PAD_CFG_STRUCT(pad,		\
-- 
2.43.0