[PATCH 13/13] imx93_qsb: Invoke the ELE voltage APIs when adjust VDD_SOC voltage

[Peng Fan (OSS)]

From: Peng Fan <peng.fan at nxp.com>

SPL will adjust VDD_SOC to OD voltage, because some PMIC uses
0.8V as default for VDD_SOC. So need to call the voltage change
APIs to avoid ELE Glitch Detection triggered reset.

Signed-off-by: Ye Li <ye.li at nxp.com>
Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 board/freescale/imx93_qsb/spl.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/board/freescale/imx93_qsb/spl.c b/board/freescale/imx93_qsb/spl.c
index 7d0f225c9b5..9e64714521b 100644
--- a/board/freescale/imx93_qsb/spl.c
+++ b/board/freescale/imx93_qsb/spl.c
@@ -81,6 +81,8 @@ int power_init_board(void)
 		printf("PMIC: Over Drive Voltage Mode\n");
 	}
 
+	ele_volt_change_start_req();
+
 	if (val & PCA9450_REG_PWRCTRL_TOFF_DEB) {
 		pmic_reg_write(dev, PCA9450_BUCK1OUT_DVS0, buck_val);
 		pmic_reg_write(dev, PCA9450_BUCK3OUT_DVS0, buck_val);
@@ -89,6 +91,8 @@ int power_init_board(void)
 		pmic_reg_write(dev, PCA9450_BUCK3OUT_DVS0, buck_val + 0x4);
 	}
 
+	ele_volt_change_finish_req();
+
 	/* set standby voltage to 0.65v */
 	if (val & PCA9450_REG_PWRCTRL_TOFF_DEB)
 		pmic_reg_write(dev, PCA9450_BUCK1OUT_DVS1, 0x0);

-- 
2.51.0