[PATCH v4 01/10] spacemit: k1: select boot device via config registers

[Eric Chung]

Add logic to determine the current boot device by reading the
SoC's configuration registers, rather than using a hardcoded
default.

Signed-off-by: Eric Chung <eric.chung at riscstar.com>

---
v2:
- Use FIELD_GET() to parse boot strap mode.
- Remove comments on hacking. Since the sequence between eMMC
  and SD device is exchanged in the upstream DTS. So it isn't
  a hacking any more.
---
 board/spacemit/k1/spl.c | 69 ++++++++++++++++++++++++++++++++++++++++++++++++-
 1 file changed, 68 insertions(+), 1 deletion(-)

diff --git a/board/spacemit/k1/spl.c b/board/spacemit/k1/spl.c
index 0db362130e4..70579637b5e 100644
--- a/board/spacemit/k1/spl.c
+++ b/board/spacemit/k1/spl.c
@@ -13,6 +13,7 @@
 #include <dm/device.h>
 #include <dm/uclass.h>
 #include <i2c.h>
+#include <linux/bitfield.h>
 #include <linux/delay.h>
 #include <log.h>
 #include <power/regulator.h>
@@ -21,6 +22,17 @@
 #include <tlv_eeprom.h>
 #include "tlv_codes.h"
 
+/* boot mode configs */
+#define BOOT_DEV_FLAG_REG	0xd4282d10
+#define BOOT_PIN_SEL_REG	0xd4282c20
+
+#define BOOT_STRAP_MODE_OFFSET	9
+#define BOOT_STRAP_MODE_MASK	3
+#define BOOT_STRAP_MODE_EMMC	0
+#define BOOT_STRAP_MODE_SPI	1
+#define BOOT_STRAP_MODE_NAND	2
+#define BOOT_STRAP_MODE_SD	3
+
 #define MUX_MODE4		4
 #define EDGE_NONE		BIT(6)
 #define PULL_UP			(6 << 13)       /* bit[15:13] 110 */
@@ -45,6 +57,17 @@ typedef void (*puts_func_t)(const char *s);
 typedef int (*ddr_init_func_t)(u64 ddr_base, u32 cs_num, u32 data_rate,
 			       puts_func_t puts);
 
+enum board_boot_mode {
+	BOOT_MODE_NONE = 0,
+	BOOT_MODE_USB = 0x55a,
+	BOOT_MODE_EMMC,
+	BOOT_MODE_NAND,
+	BOOT_MODE_SPI,
+	BOOT_MODE_SD,
+	BOOT_MODE_SHELL = 0x55f,
+	BOOT_MODE_BOOTSTRAP,
+};
+
 struct ddr_cfg {
 	u32     data_rate;
 	u32     cs_num;
@@ -379,7 +402,51 @@ void board_init_f(ulong dummy)
 
 u32 spl_boot_device(void)
 {
-	return BOOT_DEVICE_SPI;
+	void __iomem *boot_dev = (void __iomem *)BOOT_DEV_FLAG_REG;
+	void __iomem *boot_strap = (void __iomem *)BOOT_PIN_SEL_REG;
+	u32 mode, sel, ret = 0;
+
+	mode = readl(boot_dev);
+	if (mode == BOOT_MODE_NONE || mode > BOOT_MODE_SD) {
+		sel = FIELD_GET(BOOT_STRAP_MODE_MASK << BOOT_STRAP_MODE_OFFSET,
+				readl(boot_strap));
+		switch (sel) {
+		case BOOT_STRAP_MODE_EMMC:
+			mode = BOOT_MODE_EMMC;
+			break;
+		case BOOT_STRAP_MODE_NAND:
+			mode = BOOT_MODE_NAND;
+			break;
+		case BOOT_STRAP_MODE_SPI:
+			mode = BOOT_MODE_SPI;
+			break;
+		case BOOT_STRAP_MODE_SD:
+		default:
+			mode = BOOT_MODE_SD;
+			break;
+		}
+	}
+	switch (mode) {
+	case BOOT_MODE_EMMC:
+		ret = BOOT_DEVICE_MMC1;
+		break;
+	case BOOT_MODE_NAND:
+		ret = BOOT_DEVICE_NAND;
+		break;
+	case BOOT_MODE_SPI:
+		ret = BOOT_DEVICE_SPI;
+		break;
+	case BOOT_MODE_USB:
+		ret = BOOT_DEVICE_USB;
+		break;
+	case BOOT_MODE_SD:
+		ret = BOOT_DEVICE_MMC2;
+		break;
+	default:
+		ret = BOOT_DEVICE_MMC1;
+		break;
+	}
+	return ret;
 }
 
 void spl_board_init(void)

-- 
2.51.0