[PATCH 06/11] Kconfig: Add missing depends on xPL to xPL_ symbols

[Jonas Karlman]

Hi Tom,

On 7/9/2026 3:52 AM, Tom Rini wrote:
> On Wed, Jul 08, 2026 at 10:05:32PM +0000, Jonas Karlman wrote:
> 
>> xPL_<name> symbols should typically depend on the associated xPL symbol.
>>
>> Add missing depends on xPL to xPL_<name> symbols to avoid the xPL_<name>
>> symbols being available when the associated xPL symbol is disabled.
>>
>> Signed-off-by: Jonas Karlman <jonas at kwiboo.se>
>> ---
>>  common/Kconfig | 2 ++
>>  lib/Kconfig    | 7 ++++++-
>>  2 files changed, 8 insertions(+), 1 deletion(-)
> 
> Did this go through CI? I ask because with SPL/TPL, we have the problem
> of PowerPC being special from the rest of the world with these symbols
> and I want to be sure everything still is building, before I do a
> before/after size check on the series (and probably keep the binaries,
> so I can checksum before/after and make sure they're the same).
> 

The CI has been run [1] on a branch that contains these changes and the
pending Rockchip TPL cleanup/consistency series, not standalone.

Compared to the patches that was sent there is a small diff with && xPL
being dropped in the final series sent to ML:

 config xPL_SERIAL_PRESENT
        bool "Provide a serial driver in xPL"
-       depends on xPL_DM_SERIAL && xPL
+       depends on xPL_DM_SERIAL
        default y
        help
          In very space-constrained devices even the full UART driver is too

[1] https://source.denx.de/u-boot/contributors/kwiboo/u-boot/-/pipelines/30636

Regards,
Jonas