[U-Boot-Users] Re: PATCH: Add support for EmbeddedPlanet EP88x boards
Will Haines
will.haines at embedded-sys.com
Wed Jul 13 21:27:54 CEST 2005
Will Haines <will.haines <at> embedded-sys.com> writes:
> Thank you for the patch. The code should help me a lot. However, when I tried
> to test it with my board and EP885C, I got no output to the terminal.
I think that that specific error stemmed from my BDI configuration file;
however, I still cannot get the port to even print anything to the terminal. My
steps for putting to the board are as follows:
make distclean
make EP8xx_config
make all
Then with the BDI:
erase 0xfc000000
erase 0xfc020000
prog u-boot.bin bin
reset
When I reboot the board there is no output to the console.
When I try to run this using the debugger it appears that things work correctly
until the intialization gets trapped in speed.c's function: init_pll_866. I
have no idea why a function with no loops in it would seem to loop forever. My
only idea is that something is going wrong with plprcr_write_866's return jump.
Any suggestions at all to get this port running on my board would be much
appreciated!
Will Haines
More information about the U-Boot
mailing list