[U-Boot] [PATCH 1/3] fsl_i2c: Wait for STOP condition to propagate

[Heiko Schocher]

Hello Joakim,

Joakim Tjernlund wrote:
> Heiko Schocher <heiko.schocher at invitel.hu> wrote on 23/09/2009 11:02:09:
>> Hello Joakim,
>>
>> Joakim Tjernlund wrote:
>>>> Dear Joakim Tjernlund,
>>>>
>>>> In message <1253178437-32398-1-git-send-email-
>> Joakim.Tjernlund at transmode.se> you wrote:
>>>>> After issuing a STOP one must wait until the STOP has completed
>>>>> on the bus before doing something new to the controller.
>>>>>
>>>>> Also add an extra read of SR as the manual mentions doing that
>>>>> is a good idea.
>>>>>
>>>>> Remove surplus write of CR just before a write, isn't required and
>>>>> could potentially disturb the I2C bus.
>>>>>
>>>>> Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund at transmode.se>
>>>>> ---
>>>>>  drivers/i2c/fsl_i2c.c |   12 ++++++++----
>>>>>  1 files changed, 8 insertions(+), 4 deletions(-)
>>>> Could you _please_ start adding some version information to your
>>>> patches, and a list of changes between the versions?
>>>>
>>>> Thanks.
>>> Yes, that was a bit sloppy on my part, sorry. What do you want
>>> me to do now?
>>> Resend the whole series or do I get away with it this time?
>>> All but the last patch is in u-boot-i2c testing(by Heiko) repo already.
>> You mean with last patch, this patch:?
>>
>> http://lists.denx.de/pipermail/u-boot/2009-September/061187.html
> 
> Yes, that is the last one. I don't see it in testing though.

applied to u-boot-i2c testing

> I also think that
> fsl_i2c: Wait for STOP condition to propagate, fsl_i2c: Add CONFIG_FSL_I2C_CUSTOM_{DFSR/FDR}
> and fsl_i2c: Wait for STOP condition to propagate can go to WD
> 
> The fsl_i2c: Impl. AN2919, rev 5 to calculate FDR/DFSR can wait a bit longer to
> get some more testing if you think it is needed.

I wait for the end of the week (I hope, I find time to make some tests
too), and send a pull request on monday to Wolfgang.

bye
Heiko
-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany