[U-Boot] problems porting to 2013.x

[Chris Ruehl]

Hi.

I hope someone can open my eyes on this. We try to port our MX27 board to the 
new u-boot loader using the SPL code rather then the self hacked NAND->SDRAM.

I'm not able to get anything run. The console stays dead.

Let start here:
To see if the second image is booting I tried to load the image using TFTP and 
memcpy/memcmp it to the TEXT_BASE (0xa7800000) and go. The u-boot-v2 is loaded 
at 0xa7f00000.

U-Boot 2.0.0-rc9-00188-geb5172d-dirty (Mar 24 2011 - 12:59:07)
Board: MX27
NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 592 at 0x04a00000
dm9000 i/o: 0xd4000000, id: 0x90000a46
got MAC address from EEPROM: 00:00:00:00:00:00
Using environment in NAND Flash
chip id: [2,882,1,01d]
mpll:     398999390 Hz
spll:     239999725 Hz
arm:      265999593 Hz
perclk1:   66499898 Hz
perclk2:   66499898 Hz
perclk3:   66499898 Hz
perclk4:   66499898 Hz
clkin26:   26000000 Hz
ahb:      132999796 Hz
ipg:       66499898 Hz
Malloc space: 0xa6f00000 -> 0xa7f00000 (size 16 MB)
Stack space : 0xa6ef8000 -> 0xa6f00000 (size 32 kB)
running /env/bin/init...

uboot:/ tftp u-boot.bin /dev/ram0
phy0: Link is up - 100/Full
TFTP from server 10.128.2.105; our IP address is 10.128.2.10
Filename 'u-boot.bin'.
Loading: ##########################################
done
Bytes transferred = 211308 (3396c hex)
uboot:/ memcpy -s /dev/ram0 0 0xa7800000 211308
uboot:/ memcmp -s /dev/ram0 0 0xa7800000 211308
OK
uboot:/ go 0xa7800000
## Starting application at 0xA7800000 ...

System.map
a7800000 T __image_copy_start
a7800000 T _start
a7800020 t _undefined_instruction
a7800024 t _software_interrupt
a7800028 t _prefetch_abort
a780002c t _data_abort
a7800030 t _not_used
a7800034 t _irq
a7800038 t _fiq
...


Any Idea?

Chris