[ELDK] USB on Kilauea

[Stefan Roese]

Dave,

On Thursday 14 August 2008, Dave Rensberger wrote:
> Do you remember if you had to do anything out of the ordinary to force
> the OTG controller on the Kilauea to act as a host, rather than a
> device, or was that automatically taken care of by the HNP protocol
> and/or having the right cable?

IIRC, then there is a jumper on the Kilauea to configure the USB ID pin (pull 
to GND). This could be worth a try. Should be documented in the Kilauea users 
manual.

And I suggest that you don't hotplug the USB stick but have it connected 
before powering and booting the board.

BTW: Which board revision do you have? There have been issues with earlier 
board revisions. And which Linux version are you using?

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================