[ELDK] Providing ELDK specific bblayers.conf and local.conf to ease build setup

[Wolfgang Denk]

Dear Detlev Zundel,

In message <m2k3kdfwyb.fsf at lamuella.denx.de> you wrote:
> 
> according to the ELDK documentation[1], one needs to edit the provided
> configuration files to start even a first build.  It turned out that
> this phase has potential for a lot of errors, especially using the
> shared downloads directory is and was a source of confusion.  I suggest
> that we use provided config files that need no to little manual
> intervention.  We can then document the initial setup as
> 
> TEMPLATECONF=meta-eldk/conf source oe-init-build-env ....
> 
> on the wiki[1].  A subsequent "MACHINE=generic-powerpc bitbake
> core-image-minimal" then works for me without any further change.
> 
> Attached are patches to make this work against eldk 5.3 (or 5.3.1) and
> (the not released) eldk 5.4.

Thanks - will apply APASP.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
If I ever needed a brain transplant, I'd choose a teenager's  because
I'd want a brain that had never been used.