[U-Boot-Users] Warning : eepro100 driver cause problems with HardHat Linux

["Callebaut, Benoît"]

Hello,
	On our board (PPC8245 based) with 2 82559 MAC/PHY with their
interrupt lines directly connected to the interrupt lines of the processor,
the config of the mac/PHY done by PPCBoot makes problems when we leave the
MAC/PHY initialization code in PPCBoot but don't use BOOTP. the MACC/PHY
seem to not send any packet under Linux.
With the Network code disabled in PPCBoot all work fine.

----------------------------------------------------------------------------
------
Benoit Callebaut
Software Development Engineer
Barco | Control Rooms
Noordlaan 5, 8520 Kuurne, Belgium
 
Tel 	+32(0)56 36 84 28
Fax 	+32(0)56 36 86 05

mailto:benoit.callebaut at barco.com
http://www.barcocontrolrooms.com

- - - - - - - DISCLAIMER - - - - - - - - 
Unless indicated otherwise, the information contained in this message is
privileged and confidential, and is intended only for the use of the
addressee(s) named above and others who have been specifically authorized to
receive it. If you are not the intended recipient, you are hereby notified
that any dissemination, distribution or copying of this message and/or
attachments is strictly prohibited. The company accepts no liability for any
damage caused by any virus transmitted by this email. Furthermore, the
company does not warrant a proper and complete transmission of this
information, nor does it accept liability for any delays. If you have
received this message in error, please contact the sender and delete the
message. Thank you.