[U-Boot-Users] Probelm with 8266ADS board.

[ªL¯E¼á]

Hi All:
    I am using MPC8266ADS-PCI board, my board seems crash at
"relocate_code:"
and reboot again and again. So I can see the boot messages repeatly printed
on my
console. Any good ideas ? Thanks a lot.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> MESSAGES DRUING BOOTING, REPEATED
U-Boot 0.4.0 (Jul 10 2003 - 17:37:18)

MPC8260 Reset Status: Check Stop, External Soft, External Hard

MPC8260 Clock Configuration
 - Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq  25-75 , Core Freq 100-300
 - dfbrg 0, corecnf 0x0a, busdf 5, cpmdf 1, plldf 0, pllmf 2
 - vco_out  396000000, scc_clk   99000000, brg_clk   99000000
 - cpu_clk  264000000, cpm_clk  198000000, bus_clk   66000000

CPU:   MPC8260 (Rev 14, Mask A.0(A) 2K25A) at 264 MHz
Board: Motorola MPC8266ADS
I2C:   ready
DRAM:  SDRAM configuration read from SPD
        Size per side = 16MB
        Organization: 1 sides, 2 banks, 9 Columns, 11 Rows, Data width = 64
bits
        Refresh rate = 33, CAS latency = 3
        Total size: 16 MB
Top of RAM usable for U-Boot at: 01000000
haha
Reserving 190k for U-Boot at: 00fd0000
Reserving 384k for malloc() at: 00f70000
Reserving 76 Bytes for Board Info at: 00f6ffb4
Reserving 68 Bytes for Global Data at: 00f6ff70
Stack Pointer at: 00f6ff58
New Stack Pointer is: 00f6ff58
before memcpy 16187248, -268419200, 68
after memcpy

U-Boot 0.4.0 (Jul 10 2003 - 17:37:18)

MPC8260 Reset Status: Check Stop, External Soft, External Hard

MPC8260 Clock Configuration
 - Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq  25-75 , Core Freq 100-300
 - dfbrg 0, corecnf 0x0a, busdf 5, cpmdf 1, plldf 0, pllmf 2
 - vco_out  396000000, scc_clk   99000000, brg_clk   99000000
 - cpu_clk  264000000, cpm_clk  198000000, bus_clk   66000000