[U-Boot-Users] Need help booting linux on 8265 eval board

  liutomorrow at hotmail.com
Sun Apr 18 16:56:53 CEST 2004


Hi,
  I have problem  booting linux on 8265 eval board. when I boot the linux 
kernel, the board be dead. the registers look like 

to be some default values(use powertap pro). I try u-boot1.1, ppcboot1.1.5; 
linux kernel 2.4.4 2.4.18 2.4.20.

(1)about kernel
vim Makefile, arch=ppc CROSS_COMPILE=ppc_82xx
vim arch/ppc/platforms/ads826x.h, IMAP_ADDR=0x04700000 BCSR=0x04500000
then make mrproper/make ads826x_config/make oldconfig/make dep/make pImage
(bd info struct is quite same between uboot and linux) 

Is there anything I had ignored?

(2)let's see!(I add some "printf" to display values, "console=ttyS0,9600" 
is added)
=> bootm ffa00000 ffc00000
## Booting image at ffa00000 ...
   Image Name:   Linux-2.4.20-pre7ncsd1
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    634729 Bytes = 619 kB = 0 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
## Current stack ends at 0x03F7FC48 => set upper limit to 0x00800000
## cmdline at 0x007FFF00 ... 0x007FFF23
memstart    = 0x00000000
memsize     = 0x04000000
flashstart  = 0xFF800000
flashsize   = 0x00800000
flashoffset = 0x00000000
sramstart   = 0x00000000
sramsize    = 0x00000000
immr_base   = 0x04700000
bootflags   = 0x00000001
vco         = 266.666 MHz
sccfreq     = 66.666 MHz
brgfreq     = 16.666 MHz
intfreq     = 166.666 MHz
cpmfreq     = 133.333 MHz
busfreq     = 33.333 MHz
ethaddr     = 00:10:EC:00:30:8C
IP addr     = 8.6.0.1
baudrate    =   9600 bps
## Loading RAMDisk Image at ffc00000 ...
   Image Name:   Simple Ramdisk-Image
   Image Type:   PowerPC Linux RAMDisk Image (gzip compressed)
   Data Size:    567988 Bytes = 554 kB = 0 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
## initrd at 0xFFC00040 ... 0xFFC8AAF3 (len=567988=0x8AAB4)
   Loading Ramdisk to 03ef4000, end 03f7eab4 ... OK
## Transferring control to Linux (at address 00000000) ...

then the board is dead and the LED(FCC link) coruscate .
(I have modified clock calculations for this board. it's the reason?) 
any ideas? thanks a lot!


--
liu
liutomorrow at hotmail.com

_________________________________________________________________
免费下载 MSN Explorer:   http://explorer.msn.com/lccn/  





More information about the U-Boot mailing list