[U-Boot-Users] error starting linux ...

Alan J. Luse alanl at timeamerica.com
Wed Apr 21 17:52:07 CEST 2004

Wolfgang K-

You need to enable bzip2 compression in the U-Boot build.  It is not
enabled by default in most configurations.  Define CONFIG_BZIP2 in your
configuration header.  As noted in the U-Boot README you will need lots
of RAM to perform the decompression.

Alan Luse

-----Original Message-----
From: u-boot-users-admin at lists.sourceforge.net
[mailto:u-boot-users-admin at lists.sourceforge.net] On Behalf Of Wolfgang
Sent: Wednesday, 21 April 2004 7:05 AM
To: U-Boot-Users
Subject: [U-Boot-Users] error starting linux ...
Importance: High

Hi all,
hi wolfgang denk,

Anyone here how knows this error ?
means it bzip2 is not implemented in Uboot ? --but its an valid opt. in
mkimage ?

U-Boot 1.0.2 (Apr 21 2004 - 14:08:02)

U-Boot code: 08FC0000 -> 08FDB0A9  data: 00400000 -> 00400BD3
        BSS: 00400BD4 -> 0040B05F stack: 0040B060 -> 0041305F DRAM
Configuration: Bank #0: 00000000 64 MB Bank #0: Micron / Intel 28F640J3A
Flash: 16 MB
set_irq(): map INTA to IRQ9
        00  11  8086  1209  0200  09
In:    serial
Out:   serial
Err:   serial
Net:   i82559#0

***SC520  BOARD last stage init done***
boot =>
boot =>
boot => bootm 8000000
U-Boot Command_code_tabelle: 08FD3EEA -> 08FD4324
 U-Boot Cmd_table_start_search: 08FD3EEC
 ## Booting image at 08000000 ...
   Image Name:   Hopf Embedded Linux Kernel
   Image Type:   Intel x86 Linux Kernel Image (bzip2 compressed)
   Data Size:    839181 Bytes = 819.5 kB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
Unimplemented compression type 2
boot =>
boot =>
boot =>

Wolfgang k.

This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
U-Boot-Users mailing list
U-Boot-Users at lists.sourceforge.net

More information about the U-Boot mailing list