[U-Boot-Users] Anyone has success with MX1ADS?

[George G. Davis]

On Mon, Aug 23, 2004 at 07:35:00PM +0800, Wai-Kong Sung wrote:
> Hi,
> 
> I am new with U-Boot and I am trying to use it with Moto's MX1ADS. I 
> downloaded the u-boot-2004-08-18-2000.tar.bz2 from the DEX ftp site. I 
> It compiled( mx1ads_config and CROSS_COMPILE=arm-linux-) without problem 
> but didn't run when I downloaded to the board. I am using the MX1 
> bootstrap mode to download U-Boot.

Did you use bootstrap mode to merely download it or install it into flash?

> 
> The board is functioning since I can download and run other applications.
> 
> Any pointer would be greatly appreciate!

FWIW, I just confirmed that latest u-boot CVS +/- a few hours works on my
MX1ADS board:


U-Boot 1.1.2 (Aug 24 2004 - 11:49:40)

U-Boot code: 08400000 -> 08418414  BSS: -> 0841C868
RAM Configuration:
Bank #0: 08000000 64 MB
Flash: 16 MB
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
MX1ADS board with MC9328 MX1 (0L44N), Silicon ID 0x0005901d

Hit any key to stop autoboot:  0
MX1ADS$


I used the mx1flash install utility included in the MX1 RedBoot package
available from Freescale to install u-boot into SyncFlash on my board.
After installing u-boot into flash via mx1flash (using bootstrap mode),
I set S22-2 (BOOT1) OFF and u-boot works ok for me. Default console is on
UART1 at 115200n8.

--
Regards,
George