[U-Boot-Users] U-Boot and S3c2410

[Gerrit Van de Velde]

I'm far from an expert on the matter ;)
But I would try to set the addresses to 0x30000000 then. The kernel will
be expanded to RAM first and then a jump will be made to the address in
the RAM to start executing the kernel.

In my situation, I used 0x0 as start/entry. RAM starts on that address
too.

Regards,
Gerrit


On Mon, 2004-02-23 at 16:20, asnua at eircom.net wrote:
> So what is the difference between the load and entry addresses? All of the examples I've seen have the load and entry addresses set to be the same...ish. 0x00000000 & 0x0000000c for PPC
> In my case my SDRAM starts at 0x30000000 and ends at 0x33FFFFFF. My Flash and hence U-Boot is at 0x00.
> 
> Does the load and entry address vary depending on whether you are using vmlinux/vmlinux compressed/zImage?
> 
> Thanks,
> Dave