[U-Boot-Users] u-boot on the DB64360
amitshah at gmx.net
Wed Jul 21 06:00:21 CEST 2004
On Tuesday 20 Jul 2004 23:54, Frank wrote:
> I ported this board over to our in house designed board based on
> this system controller and it works just fine. What problems are
> you having...
I put the u-boot binary in the Flash area and reset the board. I didn't see
any console (serial) output, rather I saw some junk characters. The baud
rates were set correctly.
I didn't have to modify anything in the config, since everything was set
correctly (baud, processor type, etc).
BTW, this is a board with two 750FX processors.
More information about the U-Boot