[U-Boot-Users] eepro100 in u-boot

[петр петров]

                        Hello!
    I am porting u-boot to smdk2800 bord and use the eepro100 eth. card. I loaded the linux kernel image, but there are errors in the loaded image - approximitely 1bit to every 5KB. When I try to launch the kernel it prints message about crc error and then breaks. I have 
printed the internal card statistics and it sais, that no crc errors
had been detected. Also I checked the configuration byte 8(bit 1)( having dumped the internal registers). It is correctly set up to 1 - that means card had been forced to check the control sum. Can you give any idea of what could go wrong.
  Thank you in advance,
  Kirnasov A.