[U-Boot-Users] eepro100 in u-boot

[Wolfgang Denk]

In message <E1BnEUY-000HZh-00.ka99-mail-ru at f11.mail.ru> you wrote:
>                  
>     I am porting u-boot to smdk2800 bord and use the eepro100 eth. card. I loaded the linux kernel image, but there are errors in the loaded image - approximitely 1bit to every 5KB. When I try to launch the kernel it prints message about crc error and t
> hen breaks. I have 
> printed the internal card statistics and it sais, that no crc errors
> had been detected. Also I checked the configuration byte 8(bit 1)( having dumped the internal registers). It is correctly set up to 1 - that means card had been forced to check the control sum. Can you give any idea of what could go wrong.

Maybe you RAM is not working reliably?

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Use C++ to confuse your enemies; use C to produce stable code.