[U-Boot-Users] u-boot and bdi2000

[Wolfgang Denk]

In message <409BE936.4010604 at iti.fi> you wrote:
> 
> Is there quick hint why u-boot does not start up when bdi2000 is 
> connected to mpc5200 board.

Because you did not enter a "go" command, or used a bad address  with
the "go" ?

> problem is simple. I load my flash programming code ( rload ) to mpc5200 
> internal sram
> with bdi2000 and program u-boot to flash.  So, loading and running code 

Why that? Why don't you just use the BDI2000 to load and program  the
image to flash?

> Then when i reset system and try start u-boot it hangs in initialization 
> code but
> if i remove bdi2000 it boots u-boot without problems.

What is PC pointing to after reset, and what is  your  correct  entry
point?

> The bdi2000 initializtion file  is based one from denx ftp server. I 
> just ask, if this
> is commonly known problem before spending any bit more time for it.

I guess that reading the docs would help. See for example
"doc/README.IceCube"

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
In accord with UNIX philosophy, Perl gives you enough  rope  to  hang
yourself.              - L. Wall & R. L. Schwartz, _Programming Perl_