[U-Boot-Users] u-boot on EP8260 M 1.3

[Jeff Angielski]

On Thu, 2004-11-11 at 11:05, Nishant Galange wrote:
> I used the standard (unmodified) image of U-Boot for the EP8260 compiled using 
> the ELDK.

Is this configuration valid for revision M 1.3?

> CodeWarrior reports that the u-boot image was successfully programmed. However, 
> nothing appears on the monitor console after power-up. Even the LEDs stop glowing. 

Did you read the flash manually to verify that u-boot was written ok and
that the HRCW was written correctly?  More importantly, are you writing
both of these things to the correct location?

> I also tried to restore the HRCW using the procedure given in the manual:

Doesn't the manual assume your are using PlanetCore to configure the
HRCW via the PlanetCore command line utility?  Did you take that into
account?


Jeff Angielski
The PTR Group