[U-Boot-Users] Nothing display in terminal with uboot 1.1.3 on 8347 board!

[Wolfgang Denk]

In message <1c3e00040511250858v2e2db1e4q at mail.gmail.com> you wrote:
> 
> After we program the HRCW and uboot.bin(1.1.3) into Flash and power
> on, nothing is shown in terminal, it seems that the UART doesn't
> initialize correctlly.

Well, then debug it...

> We program the HRCW into FF800000 and uboot.bin into FFF00000, and we
> also use Debugger check the values we programed, both Flash and Memory
> can be written when power on through the Debugger we find it really
> goes to the Address FFF00100 where the start of UBoot(start.S) to run
> the uboot image, but how can I trace the running process step by step?

Use your debugger.

> If no information display in terminal, whether it is caused by the
> wrong address set in configuration file or by the serial
> initialization?

Or by any other error in your port. You have a debugger attached, use
it. That's what it was made for.

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
... bacteriological warfare ... hard to believe we were once foolish
enough to play around with that.
	-- McCoy, "The Omega Glory", stardate unknown