[U-Boot-Users] U-Boot 1.1.3 does not boot with MPC8349E

[Matthew McClintock]

Did you find a solution to your problem? Neil Chu just sent a patch in
today that corrects values in the MPC8349 readme. Can you give a listing
of the commands you used to program the new u-boot onto your board?

-Matthew


On Mon, 2005-10-10 at 18:15 +0200, flobe01 at arcor.de wrote:
> Has anybody tried to bring up U-Boot 1.1.3 together with a (Power Quicc II Pro) MPC8349E MDS Processor Board (silicon rev 1.0)? The board comes with a (probably patched) 1.1.2 version installed. I want to update it to 1.1.3 in order to be able to use a current Linux kernel (2.6.13 - U-Boot 1.1.2 seems to be incompatible due to differences in the bd_info structures, right?).
> 
> After building U-Boot and writing to the flash according to the README, the board does show no more signs of life (apart from the reset sequence leds) after hard reset.
> 
> I used crosstool 0.38 for building the tool chain with a standard ppc target (-mcpu=powerpc) and gcc 3.4.1.
> 
> Are there any board settings necessary other than those defaults in the Getting Started guide?
> 
> Thanks and regards,
> Florian.
> 
> 
> Machen Sie aus 14 Cent spielend bis zu 100 Euro!
> Die neue Gaming-Area von Arcor - über 50 Onlinespiele im Angebot.
> http://www.arcor.de/rd/emf-gaming-1
> 
> 
> -------------------------------------------------------
> This SF.Net email is sponsored by:
> Power Architecture Resource Center: Free content, downloads, discussions,
> and more. http://solutions.newsforge.com/ibmarch.tmpl
> _______________________________________________
> U-Boot-Users mailing list
> U-Boot-Users at lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/u-boot-users